SIFT (Army Aviation Information)
Practice Test questions & Answers
The typical structure of a helicopter is a ______ (fill in the blank) with a ____
(fill in the blank) protruding upward out of it. - -Fuselage (the body of the
craft), Mast.
-The engine of the craft drives power upward through the ____ (fill in the
blank) to the rotor blades, which are controlled by the pilot. - -Mast
-This main rotor is used to generate ____ (fill in the blank). - -Thrust.
-____ (fill in the blank) is balanced by a second rotor, usually a tail rotor,
which is intended to account for the effects of ____ (fill in the blank). - -
Thrust, Torque.
-What are the two main types of aircraft? - -Rotorcraft and Fixed Wing.
-The main advantage of a helicopter over an airplane is its ability to takeoff
____ (fill in the blank). It can also ____ (fill in the blank). This means
helicopters can be used to takeoff from and land in places that would be
impossible for planes. They can also perform tasks such as dropping cargo or
troops into challenging positions. - -Vertically, Hover.
-What are the different Helicopter types? - -Single Main Rotor, Tandem
Rotor, and Coaxial Rotor.
-This is the most common design for a helicopter- a ____ (fill in the blank)
rotor generating power, with a secondary rotor, such as a tail rotor, used to
offset the effects of torque. One disadvantage of this design is that some
power is used for countering ____ (fill in the blank), rather than being used
solely for lift. - -A Single Main Rotor, Torque.
-This helicopter design features two main rotating blade sections: front and
rear. Each set of blades rotates counter to the other, meaning that torque is
automatically offset. There is no need for additional measures, such as a tail
rotor, to deal with torque. Because of this, all of the power from the engine
can be used to lift. Consequently, ____ (fill in the blank) helicopters are some
of the fastest and most powerful in existence. - -Tandem Rotor Helicopter.
-This type of helicopter features two sets of blades rotating above and
beneath each other. The two sets of blades are mounted to the same mast,
but rotate in opposite directions to each other. This has the advantage of
, reducing ____ (fill in the blank) and allowing for greater cargo and passenger
capacity as a result. - -Coaxial Rotor Helicopter, Payload.
-____ (fill in the blank) is created by the engine, or engines, of the helicopter.
It is transferred into motion via the ____ (fill in the blank) and ____ (fill in the
blank). Sufficient ____ (fill in the blank) is needed to overcome the drag and
the weight of the helicopter and keep moving it forward. - -Thrust, Mast and
Rotors, Thrust.
-____ (fill in the blank) is a force which acts against thrust. In the case of
helicopters, drag is caused by the shape and size of the aircraft disrupting
the flow of air as it travels. There are several types of ____ (fill in the blank)
which impact helicopters. - -Drag
-What are the 4 different types of Drag? - -Profile Drag, Induced Drag,
Parasite Drag, Total Drag.
-____ (fill in the blank) is caused by the frictional resistance of helicopter
blades passing through the air. - -Profile Drag.
-What are the two subcomponents of Profile Drag? - -Form Drag and Skin
Friction.
-____ (fill in the blank) increases as the speed of the helicopter increases. - -
Form Drag.
-____ (fill in the blank) is caused by microscopic roughness of the helicopter
blades. Any roughness on the surface causes air to become trapped and
drag to increase. - -Skin Friction.
-____ (fill in the blank) is caused by airflow circulation around the blades
creating vortices. This type of drag increases when the helicopter is flying at
lower speeds, and decreases when it is flying at higher speeds. During low
speed flight, ____ (fill in the blank) is the main cause of drag for helicopters. -
-Induced Drag, Induced Drag.
-____ (fill in the blank) is the drag created by the helicopter components that
are external to the fuselage. For example, the landing gear, cowlings and
doors can all create ____ (fill in the blank) drag. ____ (fill in the blank) drag
slows down the speed of a helicopter by opposing thrust. - -Parasite Drag.
-____ (fill in the blank) is the sum total of the profile, induced and parasite
drag acting upon the helicopter at any given time. The point at which the
____ (fill in the blank) drag is lowest is the preferable point for maximum
endurance, best rate of climb, and minimum of descent in autorotation. - -
Total Drag.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Victorious23. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.