Journeyman Electrician Practice Test Verified Solu
Journeyman Electrician Practice Test Verified Solu
Journeyman Electrician Practice Test Verified Solu
Exam (elaborations)
Journeyman Electrician Practice Test Verified Solutions
7 views 0 purchase
Course
Journeyman Electrician Practice Test Verified Solu
Institution
Journeyman Electrician Practice Test Verified Solu
Journeyman Electrician Practice Test Verified Solutions
1. Conductors that are marked with _____ on their insulation are NOT approved for use in wet locations. - Answer: THHN. - Conductors with THHN insulation are suitable for dry and damp locations only, while THWN, THHW,
and THW insulation...
journeyman electrician practice test verified solu
Written for
Journeyman Electrician Practice Test Verified Solu
Journeyman Electrician Practice Test Verified Solu
Journeyman Electrician Practice Test Verified Solu
All documents for this subject (1)
Seller
Follow
bestscores1
Content preview
Journeyman Electrician Practice Test Verified Solutions
1. Conductors that are marked with _____ on their insulation are NOT approved for use in wet locations.
- Answer: THHN.
- Conductors with THHN insulation are suitable for dry and damp locations only, while THWN, THHW,
and THW insulation types are permitted for use in both dry and wet locations.
2. For a one-family dwelling with a demand load of 200 amperes supplied by a 120/240 volt, single-
phase electrical system, what is the MINIMUM size aluminum THW conductors needed for the service
entrance?
- Answer: 4/0 AWG.
- Service-entrance conductors must have an ampacity of at least 83% of the service rating. Therefore,
200 amperes x 83% = 166 amperes. The use of 4/0 AWG THW aluminum conductors with an allowable
ampacity of 180 amperes is appropriate.
3. For a 150 kVA, single-phase transformer with a secondary voltage of 120/240 at a multi-family
dwelling, what is the full-load current rating in amperes?
- Answer: 625 amperes.
- The full-load current can be calculated using the formula: I = (150 kVA x 1000) / 240 volts = 15,000 /
240 = 625 amperes.
4. Which of the following circuit breaker ratings is NOT standard?
- Answer: 75 amperes.
- Circuit breakers with a rating of 75 amperes are not part of the standard ampere ratings for breakers.
5. What is the MINIMUM length of free conductor that must be left at each junction box for the purpose
of splicing or making connections?
- Answer: 6 inches.
- This allows sufficient slack for making terminal connections or splices easily.
6. What is the minimum allowable size for overhead service-drop conductors?
, - Answer: 8 AWG copper.
- Overhead service-drop conductors must not be smaller than 8 AWG copper or 6 AWG aluminum or
copper-clad aluminum.
7. When using a galvanized eye-bolt as an attachment point for electrical service, what is the required
minimum height above finished grade?
- Answer: 10 feet.
- This height ensures adequate clearance for conductors to prevent damage and accidental contact
that could lead to shock hazards.
8. What is the reason for requiring electrical continuity in metallic conduits?
- Answer: To establish an effective ground-fault path and facilitate the operation of the over-current
protective device.
9. In dwelling units, at what maximum height should receptacle outlets for countertop surfaces be
installed?
- Answer: 20 inches.
- Receptacle outlets must be located above the countertop or work surface, not exceeding 20 inches,
to avoid using unsightly extension cords and ensure they don't interfere with cabinetry installation.
10. When conductors are installed in conduit or tubing that is _____ or less in length, the ampacity
adjustment factors for more than three current-carrying conductors are not required.
- Answer: 24 inches.
- This rule applies to ensure that smaller conduit runs do not necessitate adjustment factors for
ampacity.
adjustment factors for more than three (3) current-carrying conductors in raceways shall not apply
where the raceway is not more than 24 inches in length. Where more than 3 current-carrying
conductors are installed in short lengths of conduit or tubing, the heating effect caused from the
additional conductors is insignificant therefore, the allowable ampacity of the conductors is not greatly
reduced.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller bestscores1. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.26. You're not tied to anything after your purchase.
