Exam (elaborations)
Texas Wastewater A questions and answers rated A+ 2024/2025
- Course
- Institution
Texas Wastewater A questions and answers rated A+ 2024/2025
[Show more]
Content preview
Texas Wastewater AWhat is TCEQ doing to control "point source" pollution of the Texas waterways? -
ANS*Permitting of domestic wastewater plants
*Permitting of industrial wastewater plants
Describe proper design of force main wastewater lines. - ANSMinimum two fps velocity with
the smallest pump operating alone. Minimum four inch diameter pipe with 150 psi rating.
What is Standard Dimension Ratio? - ANSRatio of outside pipe diameter (OD) to wall
thickness (PVC)
Describe proper design of gravity wastewater lines. - ANSDesigned to flow half full ,under
normal conditions, at a minimum of two fps and a maximum of ten fps.
Manholes should have a minimum opening of? - ANS24 inches and be at least 4 feet wide.
pH meters should be calibrated how often? What standards should be used for calibration
purposes? - ANSDaily with at least two buffers.
What is the standard chlorine residual and minimum contact time on Texas wastewater
permits? - ANSa. 1.0 mg/L for a minimum 20 minutes detention time at peak flow b. No
chlorine residual needed if detention time is greater than 21 days
As the complexity of an organization increases, what management function becomes most
important? - ANSPlanning
What is the effective chlorine disinfecting agent? - ANSHypochlorous Acid (HOCl)
Does pH affect the chlorination process? Explain your answer. - ANSWhen using free
chlorine the disinfectant is HOCl acid. As such it is much more effective at pH's below 7.0.
Above 7.0 pH the acid begins to be neutralized.
What is the effluent chlorine residual in Texas that is standard on permits and the minimum
detention time? What is the maximum residual allowed? - ANSTexas standard is 1.0 mg/L
for a minimum 20 minutes detention time at peak flow. Maximum residual allowed is 4.0
mg/L.
A treatment plant has a clarifier that is 60 feet in diameter and is 10 feet deep. The weir is 2
feet inside the outer clarifier wall. The flow is 1.0 MGD. The weir and outflow channel is 3
feet deep. a. What is the detention time in hours? - ANSFormula
What activated process cannot nitrify in a single stage? - ANSContact Stabilization
, What is the GPM output of a piston pump with an 8-inch diameter piston with a 10-inch
stroke operating at 50 strokes per minute? - ANSFormula
A treatment plant has a clarifier that is 60 feet in diameter and is 10 feet deep. The weir is 2
feet inside the outer clarifier wall. The flow is 1.0 MGD. The weir and outflow channel is 3
feet deep.
a. What is the detention time in hours?
b. What is the surface loading in gal/ft2/day?
c. What is the weir loading in gal/linear ft/day? - ANSFormulas
A primary clarifier has a flow of 3.0 MGD and has a diameter of 100 feet. It is 12 feet deep
and has 24 inches of freeboard. What is the detention time in hours? - ANSFormulas
Anaerobic digester gas should contain? - ANS65-75% methane, 25-35% carbon dioxide and
1-5% nitrogen.
An activated sludge plant has an average daily flow of 3.5 MG. The aeration tank capacity is
1.2 MG with a MLSS concentration of 3200 mg/L. The clarifier has a capacity of 400,000
gallons with a MLSS concentration of 6,000 mg/L. The wasting rate is 40,000 gallons per
day with a MLSS concentration of 8, 000 mg/L. The effluent TSS is 18 mg/L. Assuming
volatile concentrations of 70%, what is the MCRT and what type of activated sludge plant
should this be? - ANSFormulas MCRT
What are some of the causes of filaments in the aeration basin? - ANSa. low DO
b. low organic loading
c. septic wastes
d. nutrient deficiencies .
e. high sulfur content
Good sludge quality will have a predominance of what organisms in the MLSS? -
ANSCiliated protozoa
When an RBC is operating correctly, how will the slime appear on the media? - ANSGrey to
brown 0.05 to 0.1 inches thick
According to design criteria, what are the minimum allowable diameters for a manhole? -
ANS24 inch opening and 48 inch inside diameter
What activated sludge process does not achieve complete nitrification? - ANSContact
Stabilization
In the selection of forced main wastewater piping, what is the minimum working pressure? -
ANS150 psi
The oxygen depletion of BOD dilution water should not exceed - ANS0.2 mg/L.
What is the minimum air gap when making water and wastewater connections? -
ANSMinimum of one inch or twice the inlet pipe size whichever is greater.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Qualityexam. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
83430 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now