100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
ASE Brakes A5 Test ( Exam 2 ) Questions And Answers With 100% Correct Answers $7.99   Add to cart

Exam (elaborations)

ASE Brakes A5 Test ( Exam 2 ) Questions And Answers With 100% Correct Answers

 6 views  0 purchase
  • Course
  • ASE Brakes A5
  • Institution
  • ASE Brakes A5

The flexible line connected to the front disc brake caliper is cracked. Which of the following should the technician do? a. repair the section of cracked hose using a barb fitting b. replace the hose with a new one c. replace all the rubber hoses on the vehicle d. replace all the rubber and st...

[Show more]

Preview 3 out of 17  pages

  • August 13, 2024
  • 17
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • ASE Brakes A5
  • ASE Brakes A5
avatar-seller
ACADEMICMATERIALS
ASE Brakes A5 Test ( Exam 2 )

The flexible line connected to the front disc brake caliper is cracked. Which of the following should the
technician do?



a. repair the section of cracked hose using a barb fitting

b. replace the hose with a new one

c. replace all the rubber hoses on the vehicle

d. replace all the rubber and steel hoses on the vehicle - B : replace the hose with a new one



why : brake pad burnishing conforms the friction material to the rotor



Tech A says some wheel speed sensors are incorporated with the wheel bearing assembly and must be
replaced as a unit. Tech B says some wheel speed sensors are located in the rear axle differential. Who is
correct?



a. A only

b. B only

c. A & B

d neither - C : A & B are correct. some sensors are located in the differential and some are
incorporated into the bearing assembly




why : an overfilled master cylinder reservoir cylinder would not allow for fluid expansion. this would
cause the brakes to self apply as the fluid expanded as result in brake drag



The brake pads are worn at an angle on a vehicle with a sliding brake caliper system. which of the
following is most likely the cause?

,a. worn caliper piston

b. worn caliper bushings

c. leaking caliper seal

d. leaking caliper boot - B : worn caliper bushings



why : worn bushings can cause the caliper to cock during operation. this could cause the pads to wear at
an angle



A diagnostic trouble code is set for an open wheel speed sensor on the left front sensor. The technician
measures the resistance at the sensor and finds it to be within specification. Which of the following is
the most likely cause for the wheel speed sensor code?



a. faulty ABS computer

b. open fuse

c. open wiring from the computer to the wheel speed sensor

d. shorted left front ABS modulator valve - C : open wiring from the computer to the wheel speed
sensor



why : an open in the wiring from the sensor to the computer would cause a diagnostic trouble code to
be set and the sensor to have the correct resistance



The brake warning lamp pictured above (pg. 56) stays on any time the ignition switch is on. Tech A says
this could be caused by a poor ground at the parking brake switch. Tech B says this could be caused by a
poor ground at the brake warning lamp switch. Who is correct?



a. A only

b. B only

c. A & B

d. neither A or B - D : neither A or B

, why : neither technician is correct. there is a ground present at all times to cause the light to be on all
the time



Which of the following is true concerning the above caliper? ( pg. 57 )



a. this caliper incorporates the parking brake

b. this caliper can only be used on the front

c. this caliper can only be used with Type 5 brake fluid

d. this caliper must be replaced at each brake pad replacement - A : this caliper incorporates the
parking brake



why : ^^^



Tech A says a double flare line should be replaced with an ISO flare line. Tech B says an ISO flare line
should be replaced with a double flare line. Who is correct?



a. A only

b. B only

c. A & B

d. neither - D : neither



why : neither technician is correct



The brakes are dragging on a vehicle. this could be cause by



a. overfilled master cylinder reservoir

b. low vacuum to the boost

c. bypassing master cylinder

d. quick take-up valve stuck open - A : overfilled master cylinder reservoir

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller ACADEMICMATERIALS. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $7.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

73243 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$7.99
  • (0)
  Add to cart