CMIT 350 FINAL EXAM 2024 LATEST
UPDATED TESTBANK COMPLETE 500
QUESTIONS WITH DETAILED
VERIFIED AND 100% CORRECT
ANSWERS ACTUAL BRAND-NEW
EXAM ALREADY GRADED A+
You have a workstation configured with DNS server
addresses as follows: • Primary DNS server = 192.168.1.1
• Alternate DNS server = 192.168.1.155, 192.168.1.222
In your browser, you type www.widgetsinc.com. The
workstation queries the primary DNS server for the
corresponding IP address, and the server responds with an
unknown host
message.
What will the workstation do next? -
....ANSWER...nothing
You have just connected a Windows workstation to the
network. The workstation can communicate with all
devices on the same subnet, but can't communicate with
other devices on other subnets. You use the ipconfig
command on the workstation and see the following:
C:\ipconfig
1
,Windows IP Configuration
Ethernet adapter Local Area Connection: IP Address . . . . .
. . . . . : 192.168.1.100 Subnet Mask. . . . . . . . . . :
255.255.255.0 Default Gateway. . . . . . . . : 192.168.1.1
No other devices seem to have a problem. What is the
most likely cause of the problem? - ....ANSWER. The
wrong default gateway address has been configured.
Your routers have been configured to use EIGRPv6. While
troubleshooting a routing issue, you decide that you need
to view the current state of the IPv6 routing protocol
processes on each router.
Which command should you use to do this? -
....ANSWER...show ipv6 protocols
You have decided to use ACLs on your router to restrict
TFTP traffic between networks.
Specifically, you want to allow only the host with an IP
address of 172.17.8.1 to access an TFTP server with an IP
address of 10.0.0.1 on a different network. The TFTP
protocol runs on UDP port 69. To accomplish this, you
create the following ACL on the router connecting the two
networks:
Router(config)#access-list 100
Router(config)#access-list 100 permit udp host 172.17.8.1
host 10.0.0.1 eq 69 Router(config)#access-list 100 deny
udp any any eq 69 Router(config)#access-list 100 permit
IP any any
You apply the ACL to inbound traffic on the interface
2
,(Fa0/0) connected to the 10.0.0.1/8 network using the
following commands:
Router(config)#int fa 0/0
Router(config-if)#ip access-group 100 in
After doing so, you find that all hosts on the 172.17.8.0/24
network can still access the TFTP
service on 10.0.0.1 over port 69. What can you do t -
....ANSWER...Apply the ACL to outbound traffic on the
router interface connected to the 10.0.0.0/8 network.
Which of the following commands lists a workstation's
ARP cache? - ....ANSWER...arp -a
You are configuring two Catalyst 2960 switches with
redundant connections. To reduce spanning tree
convergence times, you should configure the switches to
actively negotiate an EtherChannel using LACP channel
group 4.
Which command would you use for each redundant link? -
....ANSWER...Switch(config-if)#channel-group 4 mode
active
The users of a network are complaining that they can
connect to resources within the company, but cannot use
the Internet. The network administrator begins
troubleshooting the problem by entering privileged EXEC
mode on the company router and typing the show ip route
command. The results are shown in the Exhibit.
3
, What is the most probable cause of the problem -
....ANSWER...An incorrect next-hop route has been
statically configured on the local router.
Which of the following IPv6 addresses is used by a host to
contact a DHCP server? - ....ANSWER...ff02::1:2
You need to add VoIP and IP telephony support to a
router. Which feature set must be enabled to do this? -
....ANSWER...uck9
Which of the following are characteristics of ISATAP for
IPv6 tunneling? (Select two.) - ....ANSWER...Dual stack
routers
Dual stack hosts
RouterA and RouterB are connected with a serial link.
RouterA is the DTE device. A portion of the show
interface command output for RouterB is shown below:
RouterB#show interface s0/0/0
Serial0/0/0 is down, line protocol is down Hardware is
GT96K Serial
Internet address is 192.168.105.97/30
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
4
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller EliteExamsPlug. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $24.99. You're not tied to anything after your purchase.
