NICET FIRE ALARM
SYSTEMS LEVEL 1 EXAM
If a combination audible/visible appliances are installed, the location of the installed
appliance shall be determined by the requirements of - Answers -the visible appliance
What is the maximum number of 12-gaugethhn conductors that can be installed in 1-
inch EMT - Answers -26
Do you resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is
the equivalent resistance? - Answers -150 Ohms
I room is 200 feet long and 100 feet wide, and the 8 foot high ceiling is smooth and flat.
A spot-type heat detector has been selected that is listed for a 50 foot maximum
spacing between detectors. According to NFPA 72, how many detectors will be needed
to protect this room? - Answers -12
Fire warning equipment to be installed and residential occupancy's child produced
audible emergency evacuation signal described in - Answers -ANSI S3.41
The fire alarm system primarily power branch circuit disconnecting means must be
in______ color. - Answers -Red
A secondary power supply for protected premises shall automatically provide power
within _______ seconds of the primary power fails. - Answers -10
Under which of the following conditions shall spot type smoke detectors NOT be
installed? - Answers -When the temperature is above 100°F.
Who is responsible for maintaining Personal Protective Equipment? - Answers -OSHA
SYSTEMS LEVEL 1 EXAM
If a combination audible/visible appliances are installed, the location of the installed
appliance shall be determined by the requirements of - Answers -the visible appliance
What is the maximum number of 12-gaugethhn conductors that can be installed in 1-
inch EMT - Answers -26
Do you resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is
the equivalent resistance? - Answers -150 Ohms
I room is 200 feet long and 100 feet wide, and the 8 foot high ceiling is smooth and flat.
A spot-type heat detector has been selected that is listed for a 50 foot maximum
spacing between detectors. According to NFPA 72, how many detectors will be needed
to protect this room? - Answers -12
Fire warning equipment to be installed and residential occupancy's child produced
audible emergency evacuation signal described in - Answers -ANSI S3.41
The fire alarm system primarily power branch circuit disconnecting means must be
in______ color. - Answers -Red
A secondary power supply for protected premises shall automatically provide power
within _______ seconds of the primary power fails. - Answers -10
Under which of the following conditions shall spot type smoke detectors NOT be
installed? - Answers -When the temperature is above 100°F.
Who is responsible for maintaining Personal Protective Equipment? - Answers -OSHA
