ASE Certification Exam Questions With Correct Answers
3 views 0 purchase
Course
ASE Certification
Institution
ASE Certification
ASE Certification Exam Questions With
Correct Answers
The air pressure at the inlet of the HVLP gun is normally between:
A.10-30 psi
B.30-50 psi
C.50-70 psi
D. none of the above - answerB:30-50 psi
Painter A says that primer-surfacer will dry faster if sprayed in several coats with flash tim...
ASE Certification Exam Questions With
Correct Answers
The air pressure at the inlet of the HVLP gun is normally between:
A.10-30 psi
B.30-50 psi
C.50-70 psi
D. none of the above - answer✔B:30-50 psi
Painter A says that primer-surfacer will dry faster if sprayed in several coats with flash time
between coats. Painter B says there would be less bridging if all the primer surfacer is sprayed on
in one operation. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔A. Painter A only
The door shown above has a large number of paint chips. The paint is the original finish. Painter
A says the chips should be filled with an application of polyester glazing putty before
refinishing. Painter B says that the chips should be sanded out before refinishing. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔C. Both A and B
Which of these procedures would help find pits, blisters, and small shrunken impressions on a
plastic repaired area after priming?
A. blowing and dusting the repaired area
B. wire brushing and dusting the repaired area
D. wiping off the repaired area with thinner - answer✔C. block sanding the area with a medium
grit paper
Painter A says that if one of the air holes labeled 'A' is blocked with dry paint, it would cause the
spray gun pattern shown above. Painter B says that is the on the air holes labeled 'B' is blocked
with dry paint, it would cause the spray gun pattern shown above. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔A. Painter A only
An application of a basecoat metallic color has been made in which streaks indicate each pass of
the pray gun. Which of the following is the MOST likely cause?
A. too much drying time between coats
B. using too high an air pressure
C. wrong temperature reducer
D improper overlap with spray pattern - answer✔D. improper overlap with spray pattern
Which, if any, of these is the best way to prepare an old, grainy, thick paint for spraying?
A. strain and reduce
B. Strain and over-reduce
C. strain, over-reduce, and then strain again
D. none of these; dispose of the paint - answer✔D. none of these; dispose of the paint
A vehicle was just sprayed with a self-etching primer. Painter A says it should now be sanded
with 400-grit sandpaper. Painter B says 180-grit should be used instead. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔D. Neither A or B
Which f the following may cause solvent popping?
A. painting over rust spots
D. applying top coat too wet - answer✔B. Insufficient flash time for undercoats
The repaired of primed areas of a vehicle that were refinished with metallic basecoat/clear coat
show through the paint finish in a shadowy manner when the vehicle is in direct sunlight. Painter
A says that not mixing enough catalyst in the paint before application could be the cause. Painter
B says that failure to apply a solid color base before refinishing could be the cause. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔B. Painter B only
Medium Shadow Blue Metallic is composed of 001 Blue 21.1g, 002 LS Whiter 16.7g, 003 HS
Black 13.5g, 004 Magenta 8.0g, 005 Medium Fine Aluminum 7.9g, and 006 Medium Course
Aluminum 6.9g. The vehicle is redder than the paint mix,
Painter A says to add more Magenta to the paint mix. Painter B says to add more blue. Who is
right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔A. Painter A only
Medium Shadow Blue Metallic is composed of 001 Blue 21.1g, 002 LS Whiter 16.7g, 003 HS
Black 13.5g, 004 Magenta 8.0g, 005 Medium Fine Aluminum 7.9g, and 006 Medium Course
Aluminum 6.9g. The vehicle is redder than the paint mix,
After the color was adjusted, the car was lighter than the paint mix. Painter A says to add some
LS Whiter. Painter B says to add Medium Fine Aluminum. Who is right?
A. Painter A only
B. Painter B only
C. Both A and B
D. Neither A or B - answer✔C. Both A and B
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Brightstars. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.
