Electrical Theory And Practical Test Questions and Answers Guaranteed To Pass!!
7 views 0 purchase
Course
EWRB
Institution
EWRB
Electrical Theory And Practical Test Questions and Answers Guaranteed To Pass!!
State the permissible test result for an insulation resistance test for the electrical installation with ALL the permanently-connected electrical equipment DISCONNECTED - ANSWER 1 Mega Ohm
State the permissi...
, State the permissible test result for an insulation resistance test for the electrical
installation with ALL the permanently-connected electrical equipment DISCONNECTED
- ANSWER 1 Mega Ohm
State the permissible test result for an insulation resistance test for the electrical
installation with ALL the permanently-connected electrical equipment CONNECTED -
ANSWER 0.01 Mega Ohms
A
A three-phase induction motor normally runs on full-load. State ONE reason why this
VI
motor should not be run LIGHTLY LOADED when it runs on full load. - ANSWER -
The power factor of the motor will be poor
- The motor will be less efficient
TU
- running costs rise
A three-phase induction motor has been OPERATING NORMALLY ON FULL-LOAD.
The motor starts to over-heat even though it is drawing the normal full load current.
IS
State ONE reason why this situation would occur - ANSWER - The motor ventilation
is restricted in some manner
- The cooling fan has become detached from the motor shaft
M
A clip-on ammeter is being used to test the integrity of the insulation of a repaired Class
O
I electrical appliance, while the appliance is live. Where on the appliance would the
clip-on ammeter be used? Also state the maximum test result that would allow the
appliance to return to service. - ANSWER Clamped around the protective earthing
A
conductor and 5mA
N
Explain what is meant by the term INVERSE TIME-CURRENT CHARACTERISTIC in
relation to protective devices - ANSWER as current through the protective device
increases, the time taken to operate decreases
JP
State TWO components that are typically used to smooth the d.c output of a rectifier -
ANSWER - Capacitors
- Inductors
- Resistors
The output circuit of an autotransformer MUST BE insulated for the highest input or
output voltage of the autotransformer. State ONE reason for this requirement -
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JPNAOMISTUVIA. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.99. You're not tied to anything after your purchase.
