NEIEP 200 FINAL QUESTIONS AND ANSWERS
You are about to loosen a fishplate bolt. Which wrench would be least likely to slip? -
answers-a. 6 point box end wrench
B. 12 point box end wrench
C. Open end wrench
You are using a plumb line to check a rail for plumb. You find that at the top it measures
1" and at the bottom it measures 1 1/4". What does this tell you? - answers-a. The top of
the rail needs to go towards the center
B. The top of the rail needs to go toward the wall
C. The bottom of the rail needs to go toward the wall
You are setting up welding equipment. What is the maximum psi that the regulator for
the acetylene gas may be adjusted to? - answers-10-12 psi
You are using rollers to move a heavy elevator machine and are approaching a corner.
Which technique should you use to maneuver around it? - answers-angle front roller
gradually and continue around the corner
You are preparing to unload a truck at the loading dock and the truck is 8" higher than
the dock. What do you do? - answers-use a steel plate to span the gap
You just finished the surface inspection of a manila rope you will be using for hoisting.
What method should you use to conduct an internal inspection? - answers-slightly
untwist the strands
You are preparing to hoist rails and are inspecting your manila rope. Which of the
following is a good characteristic of manila rope? - answers-a light yellow color with a
silvery or pearly luster
A mechanic attaches a chainfall to a hoisting beam with a beam clamp. What happens
to the capacity of the hoisting beam? - answers-it is reduced to 50% of original capacity
You are rigging elevator equipment with a sling angle of 60 degrees. You are using a
shouldered eye bolt with a tapped 1/2" diameter hole. Once the shoulder is seated, what
is the minimum thread depth required? - answers-at least 3/4"
You will be hoisting 1klbs with a single leg vertical hitch. What will the sling load be
when the load is in the air - answers-1k lbs
You must attach a wire rope to a load by creating a loop with 3 u-bolt wire rope clips.
How should the clips be attached? - answers-no nuts on a dead horse
, You are using a bowline knot- what is one disadvantage of this knot - answers-is can
easily loosen when not loaded
You are preparing to lift a load and need to tie the ends of two ropes together. Which
knot should you use? - answers-square
The rated load tag on a sling is 2000lbs. What does this mean? - answers-load limit that
can be picked and held
You are plumbing rails on a high rise installation. What type of plumb line should you
use? - answers-a. Nylon string
B. Monofilament wire
C. Piano wire
You need to cut into a concrete wall. Which tool should you use? - answers-disc grinder
with a diamond blade disc
You need to select a heavy duty drill for drilling 5/8" holes in a machine beam. What
factor determines the drill rating? - answers-chuck size
You are tasked with setting 3/4" concrete anchors. Which type of drill should you use? -
answers-rotary hammer
You need to cut and 8ft section of 1/2" emt conduit pipe. What would be the best tool for
the job? - answers-hacksaw with 24 teeth per inch
You are directed to move oxy-acetylene cylinders from a storage area to a work site.
What is the proper way to transport them? - answers-in an upright position
You need to lift rails to the top floor of a building. With a well wheel at the top of the
hoistway, what type of rope should you use? - answers-synthetic
A crane is needed to hoist controllers on to the roof. Who is responsible for making the
lift plan? - answers-lift director
During elevator install you need to rig equipment to the top of the building. What info
must be included in the lift plan? - answers-capacity of rigging material
The crane operator is awaiting you signals to lift a pallet of parts. What are the correct
audible signals to raise the load 20 feet? - answers-hoist, hoist up, 20,15,10,1, hoist
stop
You are storing fiber core wire rope slings. What could cause damage to the core
material? - answers-solvents
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller GEEKA. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $11.99. You're not tied to anything after your purchase.