100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
Previously searched by you
IICL CONTAINER INSPECTOR FINAL EXAM ACTUAL CORRECT QUESTIONS AND VERIFIED DETAILED ANSWERS |FREQUENTLY TESTED QUESTIONS AND SOLUTIONS |ALREADY GRADED A+|BRAND NEW VERSIONS!!|GUARANTEED PASS|LATEST UPDATE$22.49
Add to cart
IICL CONTAINER INSPECTOR FINAL EXAM ACTUAL CORRECT QUESTIONS AND VERIFIED DETAILED ANSWERS |FREQUENTLY TESTED QUESTIONS AND SOLUTIONS |ALREADY GRADED A+|BRAND NEW VERSIONS!!|GUARANTEED PASS|LATEST UPDATE
3 views 0 purchase
Course
IICL CONTAINER INSPECTOR
Institution
IICL CONTAINER INSPECTOR
IICL CONTAINER INSPECTOR FINAL EXAM
ACTUAL CORRECT QUESTIONS
AND VERIFIED DETAILED ANSWERS
|FREQUENTLY TESTED QUESTIONS AND
SOLUTIONS |ALREADY GRADED A+|BRAND
NEW VERSIONS!!|GUARANTEED
PASS|LATEST UPDATE
IICL CONTAINER INSPECTOR FINAL EXAM
2024-2025 ACTUAL CORRECT QUESTIONS
AND VERIFIED DETAILED ANSWERS
|FREQUENTLY TESTED QUESTIONS AND
SOLUTIONS |ALREADY GRADED A+|BRAND
NEW VERSIONS!!|GUARANTEED
PASS|LATEST UPDATE
Where should the reference line be placed in order to determine repairworthiness of a crossmember
flange that is bent upwards?
A. Along the inside lower formed edge of the crossmember
B. Spaced out from the crossmember web
C. On the outermost flange surface along the full crossmember length
D. No measurement is necessary
D. No measurement is necessary
The damaged top rail X below is to be repaired by sectioning. Care must be taken to ensure that damage
area X is NOT cut less than a minimum of
A. 50mm (2 in)
B. 100mm (4 in)
C. 150mm (6 in)
D. 200mm (9 in)
C. 150mm (6 in)
Rework of previously straightened panels is required when
A. evidence of considerable hammer marks is present
B. the owner's policy requires repair
C. the straightened area is an incorrect color
D. original profile of the corrugation is changed
B. the owner's policy requires repair
Door gaskets that are cut may be repaired by using cyanoacrylate adhesives to bond together the cut
edges of the gasket, PROVIDED
(I) No gasket material is missing
(II) The cut edges of the gasket mate together
(III) The cyanoacrylate adhesive will fill voids that exist at the joint
1|Page
,A. I only
B. I and II only
C. II and III only
D. I, II and III
(I) No gasket material is missing
(II) The cut edges of the gasket mate together
B. I and II only
With wooden flooring, height variance between adjacent planks or panels is limited to
A. 5 mm (3/16 in)
B. 10 mm (3/8 in)
C. 15 mm (9/16 in)
D. 20 mm (3/4 in)
A. 5 mm (3/16 in)
In the Guide for Container Damage Measurement, IICL recommends a standardized procedure using set
"reference dimensions" to determine if panel bows exceed ISO tolerances plus an additional IICL
tolerance. The reference dimension for an outward bow in a side panel is
A. 5 mm (3/16 in)
B. 10 mm (3/8 in)
C. 13 mm (1/2 in)
D. 18 mm (11/16 in)
D. 18 mm (11/16 in)
Each of the following components has a single 30 mm (1 1/4 in) dent. Which one requires repair?
A. Corner post
B. Door panel
C. Roof bow
D. Bottom side rail
A. Corner post
For which of the following repairs does IICL recommend the use of pre-blasted steel?
A. Sectioning of a tube-type top side rail 3 m (10 ft ) in length
B. Replacement of a side panel 122 x 244 cm (4 x 8 ft)
C. Inserting of a front corner post 182 cm (6 ft) in length on a high-cube container
D. Full exterior container refurbishment
B. Replacement of a side panel 122 x 244 cm (4 x 8 ft)
When heat is used to straighten a corner post, the damaged area should be heated no more than
A. 550 C (1022 F)
B. 650 C (1200 F)
C. 750 C (1300 F)
D. 850 C (1560 F)
2|Page
, B. 650 C (1200 F)
Which of the following defects requires repair?
A. A loose door gasket
B. A bent J-bar that does not affect door operation
C. A dent 13mm (1/2 in) deep on the door sill
D. Four dents, each 11mm (7/16 in) deep, on contiguous outboard corrugations of a roof panel
A. A loose door gasket
Of the following conditions in a dry-van container, which one would require cleaning?
A. Raised mud foot prints in excess of what might normally remain after a sweep out
B. Dry dust covering dried floor stains as might normally be found after a sweep out
C. Coffee beans remaining inside the container as might occur after a sweep out
D. Polyurethane beads as might be expected to lodge in grooves between floorboards after a sweep out
C. Coffee beans remaining inside the container as might occur after a sweep out
An Equipment Interchange Receipt (EIR), based on an inspection with no damage found, can be
evidence of a container's compliance with: A. Australian Timber Component Treatment Regulations B.
Convention for Safe Containers (CSC) regulations through the ACEP Program
C. Transport under custom's seal (TIR) regulations D. International Standards Organization (ISO) CEDEX
codes regulations
B. Convention for Safe Containers (CSC) regulations through the ACEP Program
The top of a replacement plastic ventilator should be centered what distance from the top side rail? A.
50-55mm (2-2 3/16 in) B. 70-75mm (2 5/8 - 3 in)
C. 100mm (4in) D. 150mm (6 in)
A. 50-55mm (2-2 3/16 in)
When must a reference line extend the full length of a bottom side rail? A. When there are two or more
areas of damage on the bottom side rail B. When there is a sharp bend in the bottom side rail
C. When there is a bowing over the entire bottom side rail D. When there is additional damage to the
bottom side rail so that the reference line cannot be positioned over the ends of the damage
C. When there is a bowing over the entire bottom side rail
Which of the following is NOT a transverse structural member of the container?
A. Front sill B. Tunnel rail
C. Rear header
D. Crossmember
B. Tunnel rail
A steel corner fitting is being replaced. To ensure better weld penetration, IICL recommends that the
edges of parts adjacent to the corner fitting be ground to a minimum bevel of? A. 30 degrees B. 45
degrees
C. 55 degrees D. 60 degrees
3|Page
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Dredward. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $22.49. You're not tied to anything after your purchase.
