Section 1-3 ASE Questions with Correct Answers

Section 1-3 ASE Questions with Correct Answers Two technicians are discussing measurement systems. Technician A says liters, meters, and grams are measurement values in the standard (US Customary) system. Technician B says the metric system is based on the power-of-ten concept. Who is right? A only B only Both A and B Neither A nor B - Ans:-B only A steel ruler typically has accuracy down to ______ of an inch. 1/16 1/32 1/64 ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 2/6 1/128 - Ans:-1/32 If a brake disc is measured to be 0.657″ thick, the measurement tool most likely used is a ______. A. feeler gauge B. tape measure C. steel ruler D. micrometer - Ans:-D. micrometer Two technicians are discussing feeler gauges. Technician A says tire pressure can be measured using a tire feeler gauge. Technician B says engine cylinder combustion pressure can be measured using a cylinder bore feeler gauge. Who is right? A only B only Both A and B Neither A nor B - Ans:-Neither A nor B ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 3/6 In the standard (US Customary) measurement system, vacuum is measured in units of ______. A. bar B. pounds-per-square inch C. inches of mercury D. kilopascals - Ans:-C. inches of mercury Two technicians are discussing a fluid gauge set. Technician A says a transmission fluid gauge set typically includes a variety of adapters for different transmission designs. Technician B says oil pressure gauge tools connect directly to the oil dipstick. Who is right? A only B only Both A and B Neither A nor B - Ans:-A only A technician uses a digital multimeter to measure ______ values in a vehicle's electrical system. ©GRACEAMELIA 2024/2025 ACADEMIC YEAR. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER 2024 Page 4/6 A. voltage B. amperage C. resistance D. All of the above - Ans:-D. All of the above Two technicians are discussing torque wrenches. Technician A says a click-type torque wrench is adjusted by rotating the handle. Technician B says fixed-value torque wrenches are often used for lug nuts and oil drain plugs. Who is right? A only B only Both A and B Neither A nor B - Ans:-Both A and B Two technicians are discussing lifting a pickup truck using a flo