Questions and CORRECT Answers
Technician A says that a type of masking tape may be called fine line.
Technician B says that information labels may be masked when refinishing.
Who is right? - CORRECT ANSWER- ✔✔Both A and B
When removing a stain on fabric carpets and seats: - CORRECT ANSWER- ✔✔test the
cleaner on a hidden area of the fabric.
Which of these is a proper spray pattern? - CORRECT ANSWER- ✔✔The Answer is B.
Isocyanates: - CORRECT ANSWER- ✔✔are an irritant.
Technician A says that self-etching primer contains acid.
Technician B says that self-etching primer is applied to bare plastic.
Who is right? - CORRECT ANSWER- ✔✔A only
Technician A says that a class "A-B-C" fire extinguisher is used for flammable liquids.
Technician B says that a class "D" fire extinguisher is used for combustible metals.
Who is right? - CORRECT ANSWER- ✔✔Both A and B
Technician A says that to remove a scratch, level the surrounding finish to the depth of the
scratch.
Technician B says that a scratch in a clearcoat finish that is 2 mils deep can be removed by
detailing.
Who is right? - CORRECT ANSWER- ✔✔A only
Technician A says that a fluid control knob that is set too heavy may lead to poor hiding.
Technician B says that a fluid control knob that is set too light may lead to runs.
Who is right? - CORRECT ANSWER- ✔✔Neither A nor B
, Which of these materials may apply a zinc coating to the steel? - CORRECT ANSWER-
✔✔Self-etching primer
Which of these adhered emblem removal methods uses a see-saw cutting motion? -
CORRECT ANSWER- ✔✔Fishing line
Self-etching primer should be: - CORRECT ANSWER- ✔✔topcoated with primer-sealer.
Technician A says that to remove the belt-line molding, the exterior mirror may need to be
removed.
Technician B says that to remove the exterior mirror, the interior door trim panel may need to
be removed.
Who is right? - CORRECT ANSWER- ✔✔Both A and B
Which of these is the first step in refinishing a bare plastic part? - CORRECT ANSWER-
✔✔Soap and water
Technician A says that thinner viscosity products require higher pressure to spray evenly.
Technician B says that you may need specific fluid needles and nozzles depending on the
viscosity of the material.
Who is right? - CORRECT ANSWER- ✔✔B only
Which of these is the coarsest grit abrasive that may be used on bare aluminum? - CORRECT
ANSWER- ✔✔80 grit
Technician A says that plastic parts should be cleaned with an anti-static cleaner before
applying any coatings.
Technician B says that plastic parts should be cleaned with an anti-static cleaner after
applying sealer.
Who is right? - CORRECT ANSWER- ✔✔Both A and B