100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Ignition system Questions and Answers 2024 $14.49   Add to cart

Exam (elaborations)

Ignition system Questions and Answers 2024

 5 views  0 purchase
  • Course
  • Pa emission
  • Institution
  • Pa Emission

Exam of 7 pages for the course Pa emission at Pa emission (Ignition system)

Preview 2 out of 7  pages

  • October 30, 2024
  • 7
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • Pa emission
  • Pa emission
avatar-seller
julianah420
Ignition system

The ________ connect the coil to the distributor cap center terminal and the distributor
cap side terminals to the terminals on the top of the spark plugs. - answer High tension
leads

A ________ shows all the cylinders firing in sequence. - answer Parade pattern

Finding breakdowns in coil insulation requires the coil to be activated and the available
voltage to be measured on a(n) ________ and compared to specifications. – answer O-
scope

Tech A says that a lambda greater than 1 means the engine is running rich. Tech B
says that the amount of oxygen in the exhaust indicates how rich or lean the mixture is.
Who is correct? - answerTech B

Because the value of the self-induced voltage in the ________ is also influenced by the
rate of collapse of the magnetic field, which is determined by the rate of change of the
current flow through the coil, it is essential that the ______ be switched off as quickly as
possible. - answerPrimary winding;primary current

As the stationary winding of induction-type systems is influenced by the magnetic field,
a ________ is induced in the winding each time the ________ changes. -
answerVoltage, magnetic field

Tech A states that modern vehicles make use of a distributor to create the spark. Tech
B states that modern vehicles no longer use a distributor. Who is correct? - answerTech
B

The power train control module (PCM) must control a high-current fuel pump. The best
actuator to use would be a: - answerRelay

Ignition systems operate according to the laws of induction observed by: -
answerFaraday

Tech A says that the positive side of the coil primary circuit is switched. Tech B says
that the negative side of the coil primary circuit is switched. Who is correct? -
answerTech B

If the reach is too ________, the piston may strike the spark plug while moving up. -
answerLong

, Tech A says that spark ignition typically occurs before TDC. Tech B says that spark
ignition typically occurs after TDC. Who is correct? - answerTech A

Which component of the contact breaker point ignition system provides the driver
control over system operation? - answerThe ignition switch

Tech A says that spark plug heat range is how much heat spark plugs can physically
handle. Tech B says using the wrong heat range plug can result in spark plug damage.
Who is correct? - answerNOT both

The ________ steps up the low voltage in the primary circuit to the high voltage in the
secondary circuit. - answerInduction coil

The condition in which the magnetic field is completely built is called coil ________.
Select one: - answerSaturation

Older ignition systems used a mechanical advance that was typically controlled by: -
answerNOT breaker plates

If there is no power to the ________ side and/or no switching at the ________ side, the
ignition coil or primary wiring may be defective. - answerPositive:negative

In electronic ignition systems, a(n) __________ uses a power transistor to turn the
primary circuit on and off. - answerIgnition module

Tech A says that coil-on-plug ignition systems use one coil to fire two cylinders. Tech B
says that you should twist spark plug boots before removing them. Who is correct? -
answerTech B

Manufacturers design their ignition systems to have an amount of ________ above the
________ so that misfire is prevented.
Select one: - answerReserve voltage; required voltage

If an engine cranks but will not start, the crankshaft and camshaft positions should be
tested before performing a spark test. - answerFalse

A(n) ________ system was a mechanical ignition system with a switch, called contact
breaker points. - answerContact breaker point ignition

A low firing line indicates low resistance, a short in the circuit, or low compression. -
answerTrue

Spark plugs either use a ________ design or a washer type of gasket to form a seal
between the spark plug and the cylinder head. - answerTaper

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller julianah420. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $14.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

67866 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$14.49
  • (0)
  Add to cart