Class a extinguisher - Study guides, Class notes & Summaries

S-12 S-13 Standpipe and Sprinkler Practice Questions with Certified Solutions "Fail Safe" when referred to in locks, means that the door can be opened if the power fails Where does the on-duty Building Evacuation Supervisor report when an alarm is activated? To the Fire Command Station ( To act as Fire Safety Director when the FSD or a Deputy FSD is not required to be on duty). "RCNY" is the abbreviation for Rules of the City of New York A fire alarm box is painted plain red (no stripe). ...

If you inhale phenolic fumes what would happen to you? Trouble breathing A _________ fire extinguisher should be used on an electrical fire. Class C What does OSHA stand for? Occupational Safety & Health Administration This type of drawing represents a three-dimensional object using several two-dimensional views of the object. Orthographic What are linear dimensions usually expressed in? Decimal or Fractional Units What does a filled triangle represent in a fluid po...

Beef and veal bones - Answer-use bones with some meat still clinging to them to give the stock a richer flavor Dr.Tim Ryan - Answer-President of The Culinary institute of America Three potential Hazard - Answer--Biological hazard -physical hazard -Chemical hazard Biological hazards - Answer--Bacteria -viruses -Parasites -fungi (including molds) What does FAT TOM stands for? - Answer-Food Acidity Temperature Time Oxygen Moister What is the temperature danger zone? - A...

DHL Interview ATPL Questions with 100% Correct Answers What is the VOR change over distance? - answer60NM What is the minimum distance between parallel runways? - answer915m what the key points of using Mode 2 for parallel runways? - answerOnly straight in approaches allowed interception angle of no more that 30 degrees must be straight and level 1NM for localiser must be straight and level 2NM for Glideslope Minimum separation of 3NM on same Loc Min separation of 2 NM on adjacent Loc ...

FEX Seattle Study guide Exam Questions and Answers 2024/2025 Solved 100% General labeling types for water based extinguishers - answerANSI/UL626 and CAN/ULC- S507 Extinguishers manufactured prior to what date are not required to have as strict of labeling standards? (Labeling code 4.1.2) - answer1/1/1986 Obsolete Extinguishers - answerSoda acid, chemical foam, vaporizing liquids, cartridge operated water, cartridge operated loaded stream, copper or brass shell joined by soft solder or ri...

The maximum height for listed vehicles is - 13' 6" A load must not extend more than __ feet to the front of the vehicle, or more than ___ feet to the rear of the vehicle except poles, piling and logs. - 4, 8 Poles, piling and logs may project ___ feet beyond the rearmost part of the trailer. - 15 If a load extends for 4 or more feet past the bed or body of any vehicle, a ___ flag 12 inches square must be attached to the extreme rear of the load during daylight hours. - Red At night...

IFSTA 7 Essentials Chapter 6 Test Questions And Answers 100% Solved 2024 Class A portable fire extinguishers are rated from 1-A through 40-A based upon the amount of water and: - answerduration and range of discharge used in extinguishing test fires. A portable fire extinguisher must be labeled with the: - answerletters and/or symbols that designate its class rating. Class K rated extinguishers work because of _____, which converts fatty acids into a soapy film. - answersaponification Wh...

THE COF HOLDER MUST KEEP THE COF ___________ OR READILY AVAILABLE FOR INSPECTION - AnswerUPON HIS OR HER PERSON PORTABLE LPG CONTAINERS THAT ARE MORE THAN ________ MUST NOT BE STORED, HANDLED, OR USED INDOORS. - Answer-16.4 OZ PERMITS SHALL BE READILY AVAILABLE ON THE _________ FOR INSPECTION BY FIRE DEPARTMENT REPRESENTATIVES. - Answer-PREMISES HOT WORK PERMITS SHALL BE AVAILABLE FOR INSPECTION BY ANY REPRESENTATIVE FOR __________ AFTER THE WORK IS COMPLETE. - Answer-48 HOURS FOR _______...

Which of the following are a type of sprinkler? A) ESFR B) EC C) AF D) A and B - A and B Foam water system design and installation requirements are regulated by ___________. A. NFPA 13 B. NFPA 13R C. NFPA 25 D. NFPA 16 - NFPA 16 True or False, NFPA 72 allows only manual pull stations and water flow detection devices to be used on shunt systems. Fire detection devices are not permitted. - True The fire alarm control panel (FACP) is essentially the _____ of the system. - Brain Heat ...

CDL PASSENGER ENDORSEMENT QUESTIONS AND ANSWERS 100% PASS You are driving a 40 foot bus at 30 mph. The road is dry and visibility is good. You should keep a safety space in front of your bus thatis at least ___ seconds. 4 A hazard is defined as: any condition which may cause your trip to be unsafe A standee line on a bus: is the line that all riders must stay behind while the bus is moving Your bus is disabled. The bus, with riders aboard, may be towed or pushed to a safe spot to discharge t...