Ase brakes exam Study guides, Class notes & Summaries

ASE BRAKES Exam #3 Questions and Answers (Graded A)

ASE BRAKES Exam #1|Complete Answers Graded A+ A A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? A. Low brake fluid B. Air in the brake fluid C. Low power steering fluid D. An overtightened power steerin...

A - Answer- The brakes are dragging on a vehicle. This could be caused by: A. Overfilled master cylinder reservoir. B. Low vacuum to the booster. C. Bypassing master cylinder. D. Quick take-up valve stuck open. B - Answer- The brake pads are worn at an angle on a vehicle with a sliding brake caliper system. Which of the following is the most likely cause? A. Worn caliper piston B. Worn caliper bushings C. Leaking caliper seal D. Leaking caliper boot C - Answer- A diagnostic troubl...

T4 ASE Brakes Exam with complete Graded A+ solutions Which of the following could cause the brakes on a truck to wear too fast? A. glazed drums B. wrong linings installed C. Low air pressure D. governor cut out pressure B. wrong linings installed which of the following could cause one brake on a truck to wear faster than the others? A. mismatched service brake chambers B. mismatched parking chambers C. low air pressure in service tanks D. governor cut out too low A. mismatched se...

A - correct answer A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - correct answer A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? A. Low brake fluid B. Air in the brake fluid C. Low power steering fluid D. An overtightened power steering belt D - co...

ASE Brakes A5 Test (Exam 1), ASE A5 Brakes, ASE Brakes A5 (Exam 3 ), ASE Brakes A5 Test ( Exam 2 ) – Questions & Answers

ASE A5 BRAKES EXAM NEWEST ACTUAL EXAM COMPLETE 240 QUESTIONS AND CORRECT DETAILED ANSWERS (VERIFIED ANSWERS) |ALREADY GRADED A+||BRAND NEW!!

ASE BRAKES Exam #4 Questions and Answers Four channel ABS sensors will have how many ABS wheel speed sensors? A. Two B. Four C. Six D. Eight - CORRECT ️️ B The metering valve: A. Limits front brake application until the rear brakes apply. B. Limits rear brake application until the front brakes apply. C. Limits front brake application based on vehicle height. D. Limits rear brake application based on vehicle height. - CORRECT ️️ A A wheel cylinder has been honed. It should be c...

Four channel ABS sensors will have how many ABS wheel speed sensors? A. Two B. Four C. Six D. Eight correct answer: B The metering valve: A. Limits front brake application until the rear brakes apply. B. Limits rear brake application until the front brakes apply. C. Limits front brake application based on vehicle height. D. Limits rear brake application based on vehicle height. correct answer: A A wheel cylinder has been honed. It should be cleaned with: A. Alcohol. B. Mineral...

What would a C-clamp be used for during disc brake service? A. Seating the pads on the rotor B. Seating the caliper on the guides C. Retracting the piston in the bore D. Compressing the pads into the piston correct answer: C The red brake warning light illuminates when the brake pedal is depressed. Which of the following is the LEAST LIKELY cause? A. Air in the front brake system B. Air in the rear brake system C. Low brake fluid level D. Faulty ABS pump assembly correct answer: D ...