Boilers test - Study guides, Class notes & Summaries

Boilermaker NCCR Test Questions And Answers Boilermaker NCCR Test 1 ft 3-3/4 in + 2 ft 1-1/16 in +5 ft 10- 7/8 in = - ANS 9 ft 3-11/16 in A 1-inch plate is to be cut. Why should an acetylene gerulator on a cutting rig not be adjusted over 15 PSI? - ANS Acetylene is unstable above this pressure A big control valve is pulled who is responsible for the rigging? - ANS Crane operator and rigger A boiler maker must have all of the following wh...

MN Boiler License Questions With Complete Solutions Graded A+ a question an answer what are the conditions necessary for good combustion? a) low sulfur content b) Thermal, thermocoupler, tubular c) turbulence, temperature, time 3T's c) turbulence, temperature, time 3T's why is secondary air necessary in hand fired boilers? a) Necessary to burn the combustible gases b) if primary air should fail c) used only if sulfur content is high a) Necessary to burn the combustible gases when ...

PE 4th Part A ABSA Test Bank Questions With Complete Solutions Graded To Pass!! Introduction to Power Engineering Which of the following is not a definition of a power plant? a) Any one or more boilers in which steam or other vapour is generated at more than 103 kPa (15 psi). b) Any one or more boilers containing liquid and having a working pressure exceeding 1100 kPa (160 psi). c) Any one or more boilers containing liquid and having a working temperature exceeding 121 degrees Cel...

PE 4th Part A ABSA Test Bank Questions With Complete Solutions Graded To Pass!! Introduction to Power Engineering Which of the following is not a definition of a power plant? a) Any one or more boilers in which steam or other vapour is generated at more than 103 kPa (15 psi). b) Any one or more boilers containing liquid and having a working pressure exceeding 1100 kPa (160 psi). c) Any one or more boilers containing liquid and having a working temperature exceeding 121 degrees Cel...

MN Special Boilers License Prep Test (Use this to help study for the MN Boilers License test) Complete 2024!!

MN Special Boilers License Prep Test With Correct Answers 2024. Special (License Grade) - correct answer Work in any type of plant Grade C (License Grade) - correct answer Can operate low-pressure steam or hot water (no steam engines/turbines) Grade B (License Grade) - correct answer Can operate high-pressure or low-pressure steam or hot water (no steam engines/turbines) Grade A (License Grade) - correct answer Can operate any plant including plants with steam engines/turbines Speci...

What must you do if you notice code violations in a homeowners house? - Answer Notify them and recommend ways to address them What must be done when performing an annual tune-up on a heating system? - Answer A combustion efficiency test and a copy must be posted on site Whenever a furnace, direct fired hot water heater, or boiler is installed the total installation must be brought into compliance with what requirements BEFORE appliance can be fired? - Answer NFPA 31 When an eme...

Nyc high pressure boiler license Exam Questions with Correct Answers The minimum blowdown for a spring loaded safety valve shall be of what percent of set pressure? - Answer-10% How is the main steam pressure gages tested? - Answer-With an inspectors gage Who is in charge of the code for any plumbing installations? - Answer-The nyc plumbing code When will anchorage or guides be inspected? - Answer-Annually How many brass washout plugs does a miniature boiler have? - Answer-3 brass wa...

Minnesota Special Engineer Boiler License Exam Prep (2023/2024 Update) | Questions and Verified Answers| 100% Correct Q: A feed water line must have what two valves? Answer: Check & stop Q: After a new boiler is installed, what must be performed? Answer: Hydrostatic test Q: All stationary boilers of what pressure must have 2 valves on the blow off line? Answer: 100psi Q: How is boiler efficiency calculated? Answer: Output divided by input Q:...

What must you do if you notice code violations in a homeowners house? - Answer Notify them and recommend ways to address them What must be done when performing an annual tune-up on a heating system? - Answer A combustion efficiency test and a copy must be posted on site Whenever a furnace, direct fired hot water heater, or boiler is installed the total installation must be brought into compliance with what requirements BEFORE appliance can be fired? - Answer NFPA 31 When an emerge...

Nyc high pressure boiler license exam with question and answers latest update The minimum blowdown for a spring loaded safety valve shall be of what percent of set pressure? - ANSWER>>10% How is the main steam pressure gages tested? - ANSWER>>With an inspectors gage Who is in charge of the code for any plumbing installations? - ANSWER>>The nyc plumbing code When will anchorage or guides be inspected? - ANSWER>>Annually How many brass washout plugs does a miniature b...