Muchirigathiru
On this page, you find all documents, package deals, and flashcards offered by seller muchirigathiru.
- 189
- 0
- 0
Community
- Followers
- Following
189 items
Auto 1: final exam questions 180-200 with complete solutions
What's the main reason to measure a battery's state of charge? It indicates the battery's 
condition 
When inspecting the power steering belt, Technician A says if the belt is cracked or glazed then 
it should be replaced. Technician B says that a V-Belt should be checked with a belt tension 
gauge after the belt is replaced. Who is right? Both A and B 
While draining and refilling a differential, one should: Follow procedures using the correct 
type of fluid. 
Technician A says oil-soaked be...
- Exam (elaborations)
- • 5 pages •
What's the main reason to measure a battery's state of charge? It indicates the battery's 
condition 
When inspecting the power steering belt, Technician A says if the belt is cracked or glazed then 
it should be replaced. Technician B says that a V-Belt should be checked with a belt tension 
gauge after the belt is replaced. Who is right? Both A and B 
While draining and refilling a differential, one should: Follow procedures using the correct 
type of fluid. 
Technician A says oil-soaked be...
Auto Final Exam Questions and Answers 100% Pass
which part is the cylinder head bolted to? the block 
What is the ratio of coolant to water in a typical automotive cooling system? 50:50 
Which material are new model cylinder heads made from? aluminum 
Who issues technical service bulletins? manufacturers 
If blue smoke is seen at the tailpipe when an engine is started, which part(s) is/are most likely 
worn out? valve stem seals 
Technician A says a water pump controls the flow of coolant through an engine. Technician B 
says an oil filter co...
- Exam (elaborations)
- • 14 pages •
which part is the cylinder head bolted to? the block 
What is the ratio of coolant to water in a typical automotive cooling system? 50:50 
Which material are new model cylinder heads made from? aluminum 
Who issues technical service bulletins? manufacturers 
If blue smoke is seen at the tailpipe when an engine is started, which part(s) is/are most likely 
worn out? valve stem seals 
Technician A says a water pump controls the flow of coolant through an engine. Technician B 
says an oil filter co...
Auto Final Exam Questions and Answers Already Passed
Technician A says a load tester can be used to check the condition of a vehicles battery. 
Technician B says a load tester can be used to check the condition of a vehicle starting system. 
Who is right Both a and B 
What tool measures voltage overtime? Oscilloscope 
What tool is used when making a electrical test on a diesel engine Luminosity timing meter 
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested. 
Technician B says and inductive wire tracer c...
- Exam (elaborations)
- • 11 pages •
Technician A says a load tester can be used to check the condition of a vehicles battery. 
Technician B says a load tester can be used to check the condition of a vehicle starting system. 
Who is right Both a and B 
What tool measures voltage overtime? Oscilloscope 
What tool is used when making a electrical test on a diesel engine Luminosity timing meter 
Technician a says and inductive wire tracer generates a DC voltage in the wiring being tested. 
Technician B says and inductive wire tracer c...
Auto-Chapter 5 Questions and Answers 100% Pass
what does an auto shop's repair area normally include? Shop stall, lift, alignment rack, and 
outside work area 
A(n)____ is a small work area where a car can be parked for repairs. Shop stall 
List the rules that should be followed when using a lift Ask for permission to use the lift, 
center the vehicle on the lift, check ceiling clearance before lifting large or tall vehicles, make 
sure lift catch is safely engaged 
Describe how a vehicle should be pulled onto an alignment rack Pulled in sl...
- Exam (elaborations)
- • 4 pages •
what does an auto shop's repair area normally include? Shop stall, lift, alignment rack, and 
outside work area 
A(n)____ is a small work area where a car can be parked for repairs. Shop stall 
List the rules that should be followed when using a lift Ask for permission to use the lift, 
center the vehicle on the lift, check ceiling clearance before lifting large or tall vehicles, make 
sure lift catch is safely engaged 
Describe how a vehicle should be pulled onto an alignment rack Pulled in sl...
Automotive 1: Chapter 9 Questions and Answers Graded A
A large repair facility recycles its used motor oil. Technician A says that only about one quart of 
high-quality oil can be recovered from each gallon of used oil that is recycled. Technician B says 
the recovery rate is about two and one-half quarts per gallon. Who is right? B only 
When checking hose conditions, which would indicate the need for replacement? -Softening 
-Hardening 
-Cracks or abrasions 
If you find fluid dripping from a vehicle, where is the likeliest direction to look for th...
- Exam (elaborations)
- • 7 pages •
A large repair facility recycles its used motor oil. Technician A says that only about one quart of 
high-quality oil can be recovered from each gallon of used oil that is recycled. Technician B says 
the recovery rate is about two and one-half quarts per gallon. Who is right? B only 
When checking hose conditions, which would indicate the need for replacement? -Softening 
-Hardening 
-Cracks or abrasions 
If you find fluid dripping from a vehicle, where is the likeliest direction to look for th...
Automotive Basics Final Questions and Answers Already Passed
Your automobile relys on what to function Several systems 
What is the best way to diagnose a system failure Look for specific components in a system 
that aren´t working 
What do components make up A system 
Coolant Heat from the engine is transferred into what liquid 
What does the Thermostat do It measures the temp of the engine and tells the water pump 
when to cycle new coolant 
What does the radiator do Allows the heat from the antifreeze to be transferred to the air that 
is being blown ...
- Exam (elaborations)
- • 23 pages •
Your automobile relys on what to function Several systems 
What is the best way to diagnose a system failure Look for specific components in a system 
that aren´t working 
What do components make up A system 
Coolant Heat from the engine is transferred into what liquid 
What does the Thermostat do It measures the temp of the engine and tells the water pump 
when to cycle new coolant 
What does the radiator do Allows the heat from the antifreeze to be transferred to the air that 
is being blown ...
Automotive chapter 2 questions and answers 100% pass
List four skills that may be needed when working as an automotive technician Computer 
technician, residential/commercial engineer, electronic engineer, tv radio technition 
What is a cooperative training program Combine classroom instructions with real world 
experience 
Which of the following is not a typical specialized technician? 
1) engineering technician 
2) steering and suspension technician 
3) brake technician 
4) drive shaft technician 4) driveshaft technician 
Describe some of the re...
- Exam (elaborations)
- • 3 pages •
List four skills that may be needed when working as an automotive technician Computer 
technician, residential/commercial engineer, electronic engineer, tv radio technition 
What is a cooperative training program Combine classroom instructions with real world 
experience 
Which of the following is not a typical specialized technician? 
1) engineering technician 
2) steering and suspension technician 
3) brake technician 
4) drive shaft technician 4) driveshaft technician 
Describe some of the re...
Automotive Chapter 3 Questions and Answers Graded A
_____ or _____ maintained tools will hurt an automotive technician's on-the-job performance 
Greasy, oily 
Name three basic parts of a toolbox Large lower roll-around cabinet, upper tool chest, a 
small carrying tray 
A toolbox's ________ is for holding frequently used tools so thye can be carried to the job in a 
single trip Small carrying tray 
In what part of a toolbox are large power tools normally kept? Lowe roll-around 
What is the basic function of tool holders? Help organize small tool...
- Exam (elaborations)
- • 5 pages •
_____ or _____ maintained tools will hurt an automotive technician's on-the-job performance 
Greasy, oily 
Name three basic parts of a toolbox Large lower roll-around cabinet, upper tool chest, a 
small carrying tray 
A toolbox's ________ is for holding frequently used tools so thye can be carried to the job in a 
single trip Small carrying tray 
In what part of a toolbox are large power tools normally kept? Lowe roll-around 
What is the basic function of tool holders? Help organize small tool...
Automotive chapter 4 quiz with Complete Solutions
Power tools are tools that use Electricity hydraulics compressed air 
Which of the following is not a common impact wrench drive size? 3/8 1/4 1/2 3/4 1/4 
Special impact sockets and extensions are easily identified because they are Flat black 
Each of the following can be used to clean parts except Air ratchet 
After using a floor jack to raise the front of a car Place the car in park, block the car's wheels, 
secure the car on jack stands 
The _____ press can be used to install gears, pulleys...
- Exam (elaborations)
- • 3 pages •
Power tools are tools that use Electricity hydraulics compressed air 
Which of the following is not a common impact wrench drive size? 3/8 1/4 1/2 3/4 1/4 
Special impact sockets and extensions are easily identified because they are Flat black 
Each of the following can be used to clean parts except Air ratchet 
After using a floor jack to raise the front of a car Place the car in park, block the car's wheels, 
secure the car on jack stands 
The _____ press can be used to install gears, pulleys...
Automotive chapter 5 questions and answers already passed
Which of the following is NOT represented by the "3 Cs" abbreviation? Customer 
Which of the following is a typical label found on vehicles? All of the answers listed 
The ________________ is used by technicians to identify engine and emission control 
information for the vehicle. Vehicle Emission Control Information (VECI) label 
The ______________ certifies that the vehicle meets the Federal Motor Vehicle Safety, Bumper, 
and Theft Prevention standards in effect at the time of manufacture. V...
- Exam (elaborations)
- • 7 pages •
Which of the following is NOT represented by the "3 Cs" abbreviation? Customer 
Which of the following is a typical label found on vehicles? All of the answers listed 
The ________________ is used by technicians to identify engine and emission control 
information for the vehicle. Vehicle Emission Control Information (VECI) label 
The ______________ certifies that the vehicle meets the Federal Motor Vehicle Safety, Bumper, 
and Theft Prevention standards in effect at the time of manufacture. V...