100% de satisfacción garantizada Inmediatamente disponible después del pago Tanto en línea como en PDF No estas atado a nada
logo-home
General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star $7.99
Añadir al carrito

Examen

General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star

 0 veces vendidas
  • Grado
  • Commercial Construction
  • Institución
  • Commercial Construction

General Contractor License - KB2 Study Prep - Full Set questions and correct answers (elaborations) with 100% accurate , verified , latest fully updated , 2024/2025 ,already passed , graded a+, complete solutions guarantee distinctions rationales| 5-star rating

Vista previa 3 fuera de 20  páginas

  • 5 de agosto de 2024
  • 20
  • 2024/2025
  • Examen
  • Preguntas y respuestas
  • Commercial Construction
  • Commercial Construction
avatar-seller
General Contractor License - KB2 Study Prep - Full
Set
.667 - ANS-The top of a 4 inch concrete slab is at one foot above the benchmark. What is the
elevation at the bottom of the slab?

"F" Channel - ANS-A kind of molding installed on the vertical wall used to accept aluminum soffit
panels is:

#6 - ANS-What is the minimum size screw for attaching gypsum board to steel studs?

#6 x 1 inch - ANS-What is the smallest sized screw that can be used to attach 1/2 inch gypsum
board to load bearing steel studs?

0.019 inch - ANS-Weep screeds shall be a minimum of _____ corrosion resistant weep screed
or plastic weep screed.

0.25 - ANS-What is the minimum thickness of fiber cement panel siding?

1 #4 reinforcing bar in top and bottom of footing - ANS-What is the minimum reinforcing bar
requirement for a slab-on-ground with turned down footings?

1 foot in 12 feet - ANS-The slope ratio of a handicap accessible ramp shall be a maximum of
_____.

1 inch - ANS-How much clearance is needed between the bottom of the roof sheathing and the
insulation for a cornice vent?

1 inch - ANS-What is the normal lap for bevel wood siding?

1 layer of # 15 - ANS-Asphalt shingles installed in warmer climates with a slope of 4 in 12 or
more should have a minimum underlayment of:

1 number 5 or two Number 4 bars in the middle third of the footing - ANS-A concrete
slab-on-ground cast monolithically with the footing shall be permitted to locate _____ as an
alternative to placement at the footing top and bottom?

1-1/2 by 3-1/2 - ANS-What is the actual size of a 2 x 4 surfaced dry piece of framing lumber?

1-1/2 inch - ANS-How large of a hole can be drilled into a steel stud?

,1-1/2 inch - ANS-The minimum depth of wire wall ties embedded in mortar of solid masonry unit
is?

1-1/2 inches - ANS-Nails used for installing Hardboard panel siding vertically must
accommodate the sheathing and penetrate the framing a minimum of how much?

1-1/4 inch - ANS-Steel wall framing track shall have a minimum flange width of _____?

1-1/4 inches - ANS-Tracks for structural steel framing shall have a minimum flange width of:

1-5/8 inches - ANS-Structural steel framing shall have a minimum flange width of:

1,087 sq. ft. - ANS-Refer to the illustration of a 2 story house w/lap siding plans, (complete set
of plans at the test center), How much siding is needed on the rear of the house? (Assume
using 6 inch siding with a 2 inch overlap, add 10% for waste and deduct 130 square feet for
doors and windows.)

1/16 inch - ANS-How close can your string line be to the cinder block wall you are building?

1/16 inch - ANS-If you are using a mason's line to build a wall, how far should the string be from
the wall?

1/2 inch - ANS-An untreated wood girder beam that sets in a pocket of a concrete foundation
wall that is subject to weather shall have a minimum air space of?

1/2 inch - ANS-The maximum slope for a horizontal drain and vent combination is _____ every
12 inches.

1/2 inch - ANS-Wall ties should be placed how far from the edge of a masonry unit?

1/2 inch - ANS-What is the thickest insulation panel that is allowed in an interior floor assembly?

1/3 acre - ANS-Refer to the illustration of a 2 story house w/lap siding plans, (available at the
testing center) How many acres is the site for the house plan?

1/4 - ANS-The maximum depth of a notch in the end of a floor joist is _____ of the depth of the
joist.

1/4 inch - ANS-How much clearance should be left between the ends of the panel and trim on
vinyl siding?

1/4 inch - ANS-What is the minimum size of a bed joint in a masonry wall at the foundation?

1/4 of depth - ANS-What is the maximum notch that is allowed at the end of a joist?

, 1/6 - ANS-According to the Code, notches allowed in the top or bottom of joists shall not exceed
what fraction of the depth of the joist?

1/6 - ANS-The maximum depth of a notch in the top or bottom of a floor joist is _____ of the
depth of the joist.

10 - ANS-A minimum tread run for stairways (other than spiral stairs) in single family dwellings
having an occupant load of less than 10 is _____ inches.

10 feet - ANS-A lot shall be graded to drain surface water away from foundation walls for a
minimum of _____ feet.

10 feet - ANS-How close to a plastic or canvas tarpulin can you place a portable heat source?

10 feet - ANS-The ground immediately adjacent to the foundation shall be sloped away from the
building at a slope of not less than 5 percent for a minimum of _____ feet

10 feet - ANS-What is the maximum allowable spacing between fire blocking in a concealed
wall?

10 to 12 cubic yards - ANS-Refer to the illustration of a 2 story house w/lap siding plans,
(complete set of plans at the test center), How many cubic yards of concrete would be required
for the footer only?

10.70 feet. - ANS-Given: Using a builder's level, the grade for a footing is being set. The bottom
of the footing will be at an elevation of 94.00. A back site to the bench mark (elevation of
100.00) has a rod reading of 4.70. If the grade is correct, the rod reading for the bottom of the
footing should be:

10% - ANS-What is the maximum slope of a footing trench before stepping is required?

12 - ANS-When installing brown cellulose insulation in an attic, how many inches of insulation
are needed to have a R38 if the R factor is 3.1 per inch?

12 inches - ANS-10 foot long planks used on scaffolding should not extend over the edges of
the support more than:

12 inches - ANS-According to code, what is the minimum required width of a footing in soil rated
at 2000 PSF for a single story building with 8 inch thick masonry walls?

12 inches - ANS-How much overlap should planks on scaffolding be that are not immovable?

Los beneficios de comprar resúmenes en Stuvia estan en línea:

Garantiza la calidad de los comentarios

Garantiza la calidad de los comentarios

Compradores de Stuvia evaluaron más de 700.000 resúmenes. Así estas seguro que compras los mejores documentos!

Compra fácil y rápido

Compra fácil y rápido

Puedes pagar rápidamente y en una vez con iDeal, tarjeta de crédito o con tu crédito de Stuvia. Sin tener que hacerte miembro.

Enfócate en lo más importante

Enfócate en lo más importante

Tus compañeros escriben los resúmenes. Por eso tienes la seguridad que tienes un resumen actual y confiable. Así llegas a la conclusión rapidamente!

Preguntas frecuentes

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

100% de satisfacción garantizada: ¿Cómo funciona?

Nuestra garantía de satisfacción le asegura que siempre encontrará un documento de estudio a tu medida. Tu rellenas un formulario y nuestro equipo de atención al cliente se encarga del resto.

Who am I buying this summary from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller AnswersCOM. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy this summary for $7.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

45,681 summaries were sold in the last 30 days

Founded in 2010, the go-to place to buy summaries for 15 years now

Empieza a vender
$7.99
  • (0)
Añadir al carrito
Añadido