Tattoo licensing Latest Questions and Correct Answers 2024

When the armature is flat on the front coil, what is the smallest gap above the rear coil? - .010 What does a smaller gap above the rear coil cause? - more power What should the armature bars be ,made of? - plain steel How does a machine run if too much of the coil core is showing? - hot What type of edges should your contact screw be hitting? - front or end of spring What type of edges should your contact screw have? - rounded and smooth What length of spring would run faster? - short spring with a high angle What type of metal should the contact screw be made of to have the highest conductivity? - Brass How does the armature bar hit the front coil core? - flat, full contact What do you want the frame on your tattoo machine to be? - non-conductive What happens when your machine is conductive of electrified? - The armature bar sticks to the coils causing the machine to stay in an "on" setting. What diameter should your binding post be? - 5/16 What happens if you use a steel contact screw - can cause unwanted sparks When setting up your machine, why would you "snug" down the eye of the needle bar? - This helps to prevent weak and jumpy lines Why is a one-piece contact screw the best choice? - screws with things added on top and can add to the vibration What are the two advantages to using a brass contact screw? - 100% conductive and keeps its shape longer than other choices How much of the contact screw needs to be touching the front spring? - a tiny contact area Why should you use plain steel for a spring rather than a coated spring? - The coating wears away quickly, which causes a bad connection What kind of reaction can you expect from a machine with a very low spring angle? - spongy and weak Which type of machine benefits best from a shorter spring? - A liner Which spring is the most important for tuning the machine? - The rear spring A machine that is very hard hitting and fast running moves the needle in and out of the skin so fast that .... - it doesn't leave enough pigment behind. What is the ideal width of the springs used on the machine? - the springs should be just as wide as the part that they are attached to