Nicet level 1 exam - Study guides, Class notes & Summaries

NICET LEVEL 1 HIGHWAY CONSTRUCTION EXAM QUESTIONS AND ANSWERS Acceptance - Answer-The written acceptance by the Department of the Work. acceptance testing - Answer-Testing conducted by the Department to measure the degree of compliance to the Contract actual cost - Answer-The computed cost using calculations provided addendum - Answer-A Contract revision or response to a Contractor inquiry issued after advertisement and before the opening of bids. as-built quantity - Answer-The quantity ...

NICET Highway Construction Inspector Level III Practice Exam 1 (56 passed new update questions and answers) During installation of traffic loops in the pavement, which three statements apply prior to and during the installation of loop wire? (Choose 3). a) Do not allow vehicular traffic over an open saw cut. b) Do not overlap saw cuts at the corner. c) Thoroughly clean the saw cut of foreign material. d) Use a plastic sleeve where loop wire crosses a joint.

what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid metal conduit? - Precise Answer 4 wires Which of the following would be an appropriate mounting height for a pull station? - Precise Answer 3.5'-48" to the actuator What is the minimum flash rate for a visible notification device? - Precise Answer 1 flash per second What is the minimum mounting height for audible notification devices? - Precise Answer 90" to the top of the device What is the mi...

NICET Level 1 inspection and Testing Exam 2024 When using a pulse load tester on a sealed lead acid battery, the minimum acceptable capacity is... -Answer-80% When a software change is made to a fire alarm system, what percentage of the initiating devices not affected by the change must be tested -Answer-10% When testing elevator recall, the elevator should go to the alternate level when: -Answer-The lobby smoke detector on the recall level is activated Minimum requirement for system docu...

4 wires Answer - what is the maximum number of 14 AWG RHH conductors which can be installed in 1/2 rigid metal conduit? 3.5'-48" to the actuator Answer - Which of the following would be an appropriate mounting height for a pull station? 1 flash per second Answer - What is the minimum flash rate for a visible notification device? 90" to the top of the device Answer - What is the minimum mounting height for audible notification devices? Such that the entire lens is not less then 80...

NICET Inspect & Test LVL 2 Exam Questions and Answers While testing a fire alarm system at a correctional facility, it is determined that the general fire alarm signal requires human intervention to be initiated. This is permitted using a _____ feature? A. Pre signal B. Positive alarm sequence C. Manual initiation D. Alarm verification - Answer-A. Pre Signal NFPA 72 23.8.1.1.2(3)(a) Consider a 50′ x 50′ room with a 12′ ceiling. What is the minimum intensity required for a ceilin...

The operable part of a manually actuated alarm initiating device shall be not less than ____ inches AFF?Answer - 42 Consider the use of grounding electrodes. Rod and pipe electrodes shall not be less than____ feet in length?Answer - 8 Smoke detectors should not be located in a direct airflow or closer than ____ inches from an air supply diffuser or return air opening?Answer - 36 Consider the use of visible notification appliances. Wall mounted appliances shall be mounted such that th...

Nicet level 1 Exam Review Questions and answers, rated A+ Whats the maximum coverage area of any fire sprinkler? 225sqft NFPA 14 Standard for the Installation of Standpipe and Hose Systems Brainpower Read More 0:07 / 0:15 NFPA 15 Standard for Water Spray Fixed Systems for Fire Protection When was OSHA founded and what does ti stand for? 1971 - the occupational safety and health administration OSHA part 1910? Applies to the general industry OSHA part 1926? Sets forth the safety...

NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Exam with Score A+ Guaranteed NICET LEVEL 1 Ex...

When using a pulse load tester on a sealed lead acid battery, the minimum acceptable capacity is... Answer - 80% When a software change is made to a fire alarm system, what percentage of the initiating devices not affected by the change must be tested Answer - 10% When testing elevator recall, the elevator should go to the alternate level when: Answer - The lobby smoke detector on the recall level is activated Minimum requirement for system documentation Answer - Battery calculations/fl...