Pumper test 2 - Study guides, Class notes & Summaries

Minimum water supply for a class 1 or 3 standpipe system is _____ gpm for at least 30mn with 65psi residual pressure at the highest outlet. - ️️500 When liquid propane gas is stored in the same area as flammable or combustible liquid, the containers must be at least ______ feet apart - ️️20 feet Fire protection engineers have established _____ PSI as a minimum required residual pressure when computing the available water for flow test results. - ️️20psi A fire pump serving a st...

INDUSTRIAL FOAM PUMPERS ARE BUILT ACCORDING TO ? - NFPA 11 C AND 1901 ( TEST ANSWER IS BOTH 11 C AND 1901) LARGEST CAPACITY pumper DURING RELAY SHOULD BE? - The source pumper WHAT IS NOT PART OF THE DAILY APPARATUS INSPECTION? - EXERCISING THE VOLUME SERIES CONTROL LEVER One gallon of water weighs? - 8.35 LBS How many cubic inches in a gallon of water - 231 cubic inches How much does a cubic foot of water weigh? - 62.5 LBS How many gallons of water in a cubic foot? - 7.481 gallons How m...

1. Fire protection engineers have established PSI as a minimum re- quired residual pressure when computing the available water for flow test results. ANS 20psi 2. The most common gallonage rating for horizontal shaft pumps in use today are - GPM. ANS 500 - 1500 gpm 3. A fire pump serving a standpipe system should be tested ANS weekly 4. A fire department pumper can effectively supply around feet in a high rise building depending on hydrant pressure and other factors. ANS 450 feet 5. Cla...

Texas Commission on Fire Protection (TCFP) Driver/ Operator Test Questions and Answers 2024/2025 | 100% Verified | Graded. NFPA 1500 What was the first gasoline powered fire apparatus to discharge water by using a large soda acid extinguisher? Chemical Wagon The real breakthrough for today's modern fire apparatus came with the introduction of the __________________ which carried a booster tank, had a pump capacity of 250 gallons per minute or greater, and carried 21/2 inch and 11/2 inch h...

In 1720 what was the piece of equipment to replace the bucket brigade? Hand Pump Which NFPA standard required new fire apparatus to be designed so that all members riding on the fire apparatus would be provided a seated area inside an enclosed cab? NFPA 1500 What was the first gasoline powered fire apparatus to discharge water by using a large soda acid extinguisher? Chemical Wagon The real breakthrough for today's modern fire apparatus came with the introduction of the _______________...

Pumper CDC Questions and Answers Fully Solved A fire apparatus should be started with all electrical switches in the OFF position in order to: Start the engine without a load. During an inspection of your fire apparatus, you should ensure that the foam level is: Full Match the location of each fire apparatus inspection item to the name that applies saddle tanks - 6 winch - 7 main hose bed - 2 automatic snow chains - 4 intake strainers - 5 ladders - 3 compartments - 1 ...

D-O Pumper CDC CCRE QUESTIONS AND ANSWERS GRADED A+ The lowest acceptable fuel gauge reading on a fire apparatus during inspection is: at least 3/4-full. The rescue tool supply system equivalent of a junction box is called: a manifold 3 conditions where you should drive your fire apparatus in low gear: 1. Approaching an intersection 2. Travelling around a corner 3. Climbing a hill Three conditions to wearing your seat belt before an emergency vehicle moves: 1. Providi...