A branch circuit Study guides, Class notes & Summaries

Worn motor bearings are most to result in a(n)___. continuous overload A high-level short circuit current may exceed ___. 50,000A` Accidental contact between an electrical conductor and a grounded enclosure is called a(n)___. ground fault Most arcing faults begin as ___. ground faults A plug fuse with a hexagonal cap has a maximum amperage rating of ___. 15A Under normal operation and at currents near its ampere rating, a fuse operates as a ___. conductor...

Module 26104 - 20 What is the total resistance of three resistors in parallel with the values of 2Ω, 4Ω & 4Ω? 1Ω 3 MULTIPLE CHOICE OPTIONS The current flowing through a hair dryer that uses 1,200 watts of power with an applied voltage of 120V is _______? 10A. 3 MULTIPLE CHOICE OPTIONS The total resistance of four equal resistors in parallel, each with a value of 10Ω, is _______ 2.5Ω 3 MULTIPLE CHOICE OPTIONS What is the total resistance of three resistors in parallel ...

Michigan Journeyman test | 2023/24 questions and answers There are six conductors in a race way connected to 75° C rated circuit breaker. Each wire has a 70 amp load using THHM conductors. The minimum size conductors used our #_________AWG - 4 Thermal insulation shall not be installed within _________inches of recessed lighting fixtures - 3 A 1 inch conduit contains three wire circuits or a phase system. All conductors are number 10 TW. Each circuit consist of two phase conductors and on...

Module 11 - Residential Electrical Services Questions and Answers 2023 with complete solution A small residence has a floor area of 900 square feet. What is its general lighting load? 2,700VA Per NEC Table 220.54, a household with two dryers has a demand factor of __________. 100% If a dwelling has two kitchen areas, then the total small appliance branch circuits required would be __________. four at 1,500VA each A lighting load of 2,700VA at 120V has an amperage of __________. 22.5A ...

Level 1 Module 10 Basic Electrical Construction Drawings Exam 2023 with complete solution A cutaway view of a building or object is known as a(n)______. Sectional drawing What is the total connected load of Circuit A-1 if each of the Type C lighting fixtures in the figure above has a total lamp and ballast load of 150VA? 1,200VA In which division of the MasterFormat is electronic safety covered? Division 28 A section line on a drawing shows The location of the section on the plan On e...

The Problem with Stucco is that it____ - ANSWER-tends to crack How should corner moldings on aluminum sliding be installed - ANSWER-upper molding overlapping A hinge door that rubs the frame may have - ANSWER-loos hinge screws Discoloration or fogging in a window is an indication of - ANSWER-a leaking insulated glass seal what would not be the cause of a sag in a porch ceiling - ANSWER-rotting fascia board what is most highly recommended for repairing aluminum branch circuit wir...

Journeyman Electrician Exam Questions and Answers 2023 Graded A+ For other than one-and two-family dwellings, when building a new electrical service, at least one (1) 125-volt, single-phase, 15- or 20-ampere-rated receptacle outlet shall be located within at LEAST _____ of the electrical service equipment? -ANS>> 50 feet The ampacity of a conductor is defined by the NEC to be the maximum current, in amperes, a conductor can carry continuously under the conditions of use without exce...

Portage Learning Anatomy & Physiology 2: Module 4 Exam 100% Pass Which body system supplies cells with oxygen and nutrients and carries away waste? A. Nervous system B. Respiratory system C. Urinary System D. Correct! Circulatory System The heart is contained in the _______ cavity. A. Correct! Pericardial B. Pleural C. Septal D. Rectoperineal Which layer of heart anchors it to the diaphragm? A. Endocardium B. Mediastinal C. Myocardium D. Correct! Pericardium What is the purpose of t...

Module 26111- Wiring Commercial and Residentiala green screw terminal on a device is to be used for the _____ wire a. grounding a device labeled CO/ALR can be used with ______ wire b. copper , aluminum, or copper-clad aluminum the UL label on a device means the device_____ d. has undergone testing it a nationally recognized lab and meets the minimum safety requirements in relation to switches, the term throw refers to the _______ c. number of internal operations that a switch ...

NCCER ELECTRICAL TEST Questions and Answers 2024 1. The NEC recommends maintaining voltage within a 3% drop. If a branch cir- cuit operates at 240 volts AC. What is the minimum circuit operating volt?: 232 2. What is the name of the connecting device shown in the diagram?: Split-bolt 3. The volt amperes in an AC circuit is the same as: Apparent power 4. What is the voltage drop for a #8 (16.510 cmil) copper wire at 120v. 215 feet one way and a load of 39amps?: 10.5