Fire damper - Study guides, Class notes & Summaries

IDPX Exam Questions and answers, rated A+ While touring the site, you noticed the transition from carpet to concrete isn't what you approved in the shop drawings and has resulted in a significant height difference that will be a tripping hazard? - - Contact the GC in writing stating you observed and that you are rejecting that portion of woek since it is not in accordance to the contract documents Who is responsible for submitting CO to the Owner? - -GC To receive periodic payments, w...

HVAC Journeyman Final Prep Study Exam Questions and Answers In wood structures, notches on the end of the joists shall not exceed ___________ the joist depth. A. one fourth B. 6% of C. 1/2 of D. 10% of - CORRECT ANSWER-A. one-fourth Underground inspection shall be made after trenches or ditches are excavated and bedded, piping installed, and ___________ backfill is put in place. When excavated soil contains rocks, broken concrete, frozen chunks, and other rubble that would damage...

The inspector must have a through knowledge and understanding of the following items: - Enabling legislation, State/Local Statues, ways to alter State/Local Statues The personnel given the responsibility for fire and life safety inspections programs are members of the: - Fire Department Categories of Inspections are: - Annual (Routine), Issuance of a permit, Response to a complaint, Eminent hazard, New Construction, Change in Occupancy, Owner/Occupant Request At the time of inspection the ...

A listed smoke damper designed to resist the passage of smoke shall be provided at each point in a duct or air transfer opening penetrates a: (A)smoke barrier wall (B)fire rated wall (C)interior wall (D)corridor wall - ANSWER Corridor wall (IMC 607.5.4) Flexible air duct may be what length? (A)10' (B)2' (C)14' (D)6' - ANSWER 14' (IMC 603.6.1.1) The maximum vertical distance between the front lower lip of a canopy Type 1 hood and the appliance surface shall be ____ feet: (A)5' (B)3' ...

Fire Inspector 1 Study Guide (State of Florida) with 100% Correct Answers The inspector must have a through knowledge and understanding of the following items: - Answer- Enabling legislation, State/Local Statues, ways to alter State/Local Statues The personnel given the responsibility for fire and life safety inspections programs are members of the: - Answer- Fire Department Categories of Inspections are: - Answer- Annual (Routine), Issuance of a permit, Response to a complaint, Eminent h...

HVAC Journeyman's Study Set Exam Final Questions and Answers The maximum horizontal length of a single-wall connector shall be ____ percent of the height of the chimney or vent. - CORRECT ANSWER-75% Grease filters shall be installed at an angle of not less that ____ degrees from the horizontal and shall be equipped with a drip tray beneath the lower edge of the filters - CORRECT ANSWER-45 A device that will automatically shut off the fuel supply to a main burner or group of burners ...

G2 Gas Technician Module 19 Revised Questions Rated A If the venting on a high efficiency furnace runs through unheated spaces, what must be done? Insulate piping to prevent Condensation and freezing What is condensate drain piping used for? Dispose Liquid waste Once the furnace is installed, what are the gas technician's responsibilities to the user? To instruct the the user in the safe and correct operation of all appliances and equipment - clause 4.3.2 Which furnace type is the most popu...

Where would you look to determine if the damper requirements have been included and correct on a set of drawings? - Answer- On the mechanical plan Which plans sheet gives specific details for exit signs? - Answer- Electrical plans Which plan would you look at to find exit door fire ratings? - Answer- Door schedule All of the following items can be verified on the life safety floor plan Except - Answer- The location of fire hydrant connections Which view should inspectors examine to s...

IEC 315 Study Guide Questions with Verified Solutions A minimum of ???? sets of batter boards is required to establish the building lines when forming a slab. Two A person working in the BCES kitchen controls the supply and exhaust (SF-21 and EF-22) by operating ??? that are wall mounted near the cooking hood. One single pole switch AHUs at BCES are to be connected using??? FMC At BCES, EF-1 is ON when AHU-1 is ON True At BCES, EF-2 is located ??? above the toilet it serves. ...

FIRE INSPECTOR 1 STUDY GUIDE (STATE OF FLORIDA)/ EXAM REVIEW QUESTIONS AND ANSWERS, 100% ACCURATE/ The inspector must have a through knowledge and understanding of the following items: - - Enabling legislation, State/Local Statues, ways to alter State/Local Statues The personnel given the responsibility for fire and life safety inspections programs are members of the: - -Fire Department Categories of Inspections are: - -Annual (Routine), Issuance of a permit, Response to a complaint, Em...