To plumb the hole - Study guides, Class notes & Summaries

NEIEP 800 Final Exam Questions and Answers 100% Pass Hydro elevators in low rise applications do not need an _____ _____ room. - Answer- overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - Answer- ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the dril...

NEIEP 200 Final Exam Questions and Answers Updated 2024/2025 (100% VERIFIED) you are about to loosen a fishplate bolt. which wrench would be least likely to slip? (Ansa. 6 point box end wrench b. 12 point box end wrench c. open end wrench you are using a plumb line to check a rail for plumb. you find that at the top it measures 1" and at the bottom it measures 1 1/4". what does this tell you? (Ansa. the top of the rail needs to go towards the center b. the top of the rail needs to go ...

Neiep 800 Final ReviewWhat is the minimum height of barricade in place around an open well way? - correct answer 42 inches What is the maximum angle of inclination for moving walks? - correct answer 12 degrees What is the major advantage of a hydraulic elevator? - correct answer Requires less building structural support If all other elements in a hydro elevator remain the same, what would be the effect of increasing the size of the oil line? - correct answer Rate of flow is reduced W...

A blaster is: - A competent person who uses explosives A ground-fault circuit interrupter (GFCI) protects workers from shock by: - Matching the amount of current going into an electrical device against the amount returning from the device and shutting down power if a ground fault is detected A noise level of 95 dB is ______ than the lowest level at which hearing protection is required (85 dB), and your exposure should be limited to six hours or less. - Ten times louder than A scaffold must...

Hydro elevators in low rise applications do not need an _____ _____ room. - overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem and bit and use a _____ _____. - Spider Bob To plumb the hole, a...

Hydro elevators in low rise applications do not need an _____ _____ room. - Answer-overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - Answerground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem and bit and use a _____ _____. - Answer-Spider Bob T...

1. You have been provided with an unfamiliar brand of solvent to clean a brake drum. What is the best source for determining whether or not it is safe to use? a. OSHA b. SDS c. Building supervisor d. Local safety committee Answer: SDS 2. 2. A ladder needs to be extended 20' from the ground floor to the next landing. How far from the wall should the base of the ladder be? a. 3' b. 4' c. 5' d. 6' Answer: C. 5' 3. 3. Which of the following procedures would you use to get into a pit t...

NEIEP 800 Final Questions and answers Hydro elevators in low rise applications do not need an _____ _____ room. - ANSWER-overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ whereas the load of a traction car is carried by the _____ _____. - ANSWER-ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem and bit and ...

Core Curriculum- Chapter 3 Hand Tools Exam Questions And Answers Updated 2024/2025 Which of the following would likely have the fewest teeth per inch, resulting in the largest teeth? Rip saw Using an adjustable wrench can save time when you are working with Different size nuts and bolts Before using a pick, check to be sure that the head is Fixed firmly to the handle When an object is plumb, it is _______________________ Horizontal Because of its stiffness, a folding rul...

NEIEP 800 Final Exam With 100% Correct Answers 2023. Hydro elevators in low rise applications do not need an _____ _____ room. - Correct Answer-overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - Correct Answer-ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to re...