50 ft Study guides, Class notes & Summaries

NFPA 10 Exam 99 Questions with Verified Answers (SI) - CORRECT ANSWER International System of Units 1 in=. mm - CORRECT ANSWER 25.4 Approved - CORRECT ANSWER Acceptable to the authority having jurisdiction. (AHJ) - CORRECT ANSWER Authority Having Jurisdiction O rganization, office or individual responsible for enforcing requirements of a code or standard, or for approving equipment, materials, an installation or procedure. Shall - CORRECT ANSWER Indicates a mandatory requirement....

NFPA 10 Exam 71 Questions with Verified Answers When should wheeled fire extinguishers be considered? - CORRECT ANSWER • High hazard areas are present. • Limited available personnel are present. Requiring: High agent flow rate, Increased agent stream range, increased agent capacity NON-DOT low pressure fire extinguisher cylinders that pass a hydrostatic test shall have the following recorded on a label: - CORRECT ANSWER • Month and year test was performed (perforated) • Test pre...

Special Engineers Exam A. 10 sq ft heating surface - correct answer For the purpose of rating boiler horsepower for an engineers license only, how many boiler square feet of boiler shall be equivilent to one boiler horsepower on a Boiler? A. 10 sq. ft. heating surface B. 5 sq. ft. heating surface C. 2.5 sq ft heating surface D. 20 sq ft heating surface B. Boilers operating at a steam or other vapor pressure of 15 psig or less, or a hot water or other liquid boiler that doesnt exceed 16...

ASD Exam Questions With 100% Correct Answers 2023 Category 1 - Correct Answer-Category of Water that originates from sanitary water source (Clean) Catetroy 2 - Correct Answer-Category of Water that is contaminated; may cause discomfort or sickness (Grey) Category 3 - Correct Answer-Category of Water that is grossly contaminated; includes toxins, pathogens Special Situation - Correct Answer-Regulated or hazardous materials Class 1 - Correct Answer-Class of water that has least amount...

What is the result if the neutral wire becomes open on a multiwire circuit having unequal loads? Select one: a. The load of higher resistance would overheat and probably be damaged. b. The load of lesser resistance would overheat and probably be damaged. c. No effect until one load is turned off or opens. d. No effect. The load of higher resistance would overheat and probably be damaged. Refer to Figure 128.202. ___ volts are applied across the water heater element. S...

what are the minimum and maximum lengths of the two way flagger taper? - 50 feet and 100 ft how far apart are the cones spaced in the 2 way taper? - 20 ft what is the minimum number of cones in a 60 ft taper? - 4 at 55 mph, how far should the flagger be from the work space - 335 at 55 mph what is the minimum distance that the driver of the first approching vehicle be able to see the flagger? - 495 at 55 mph what is the minimum distance between the flagger and the flagger sign - 500 at 40 ...

Test Bank for Cardiopulmonary Anatomy and Physiology Essentials of Respiratory Care 7th Edition by Des Jardins Chapter 2 Ventilation MULTIPLE CHOICE 1. What instrument is used to measure P atm ? a. dynameter c. barometer b. altimeter d. hygrometer ANS: C Feedback A B C D A barometer is used to measure barometric (P B A barometer is used to measure barometric (P B A barometer is used to measure barometric (P B A barometer is used to measure barometric (P B ) or atmospheric (...

Seattle FEX-1 Starter Exam Questions and Answers 2024/2025 Solved 100% What type of test is necessary on a Co2 hose before installation? - answerConductivity What is the maximum travel distance for a Class B fire extinguisher? (Light hazard, Ordinary Hazard, Extra Hazard) - answer50', 50', 50' Administrative Rating 9.01.04 states that ________ are to be followed. - answerNationally recognized standards A 10 Ft sq. heptane tank should have a ______ rated extinguisher protecting it. - a...

In dynamics, a particle is assumed to have: A) both translation and rotational motions B) only a mass C) a mass but the size and shape cannot be neglected D) no mass or size or shape, it is just a point - Answer- B) only a mass The average speed is defined as __________. A) Dr/Dt B) Ds/Dt C) sT/Dt D) None of the above. - Answer- C) sT/Dt (total distance/change in time) A particle moves along a horizontal path with its velocity varying with time as listed below. The average acc...

Lead-based paint (LBP) - Correct answer-Any varnish, shallac, or coating that contains either- 1.0 mg/cm2 - 0.5 % by weight - 5000 ppm - Older instruments could not read accurately at 0.7, so the lead standard was updated to 1.0 Dust sample clearance values - Correct answer-- Floors: 40 μg/ft2 > 10 μg/ft2 (10 μg/ft2 in NY) - Windows: 250 μg/ft2 > 100 μg/ft2 (50 μg/ft2 in NY) - Window wells (troughs): 400 μg/ft2 (100 μg/ft2 in NY) - Samples must be at 1 sq ft > 2 sq ft (can ...

ASPE CPD Study Questions AH with complete solutions. Front - correct answer. Back What is the specific weight of water? - correct answer. 62.4 lbs per cubic foot What happens in a storm and sanitary system after it passes the water test? - correct answer. A smoke pressure test is recommended with a smoke pressure of 1 in wc to prove the system gas tight. Is an air test acceptable for a storm and sanitary system? - correct answer. Yes, if a water test is not poss...

A loan whose payments do not fully liquidate the loan and thus requires a large final payment, is known as 1. Partially amortized loan 2. Term loan 3. Growing equity mortgage 4. Graduated payment mortgage correct answers 1. Partially amortized loan - Repays partially, the part of the loan that hasn't been repaid yet is called a balloon payment Graduated/Growing - accelerate repayment of their fixed-rate mortgage by scheduling additional principal payments that increase over time Re...