Crankcase test - Study guides, Class notes & Summaries

ENGINE REPAIR MICHIGAN MECHANIC STUDY GUIDE RATED A+ WHICH OF THE FOLLOWING IS TRUE ABOUT ADJUSTING VALVE TAPPET CLEARANCE A. THE VALVE TAPPET CLEARENCE ON A HIGH MILEAGE EGINE SHOULD BE ADJUSTED TIGHTER THAN SPECIFICATIONS FOR A NEWLY REBUILT ENGINE. B. VALVE TAPPET CLEARANCE SHOULD BE ADJUSTED AT TDC AT THE END OF THE COMPRESSION STROKE. (CORRECT AWNSER) C. VALVE TAPPET CLEARANCE SHOULD BE ADJUSTED AT BDC AT THE END OF THE EXHAUST STROKE. D. NONE OF THE ABOVE. (NOT CORRECT AWNS...

Mass oil burner / NFPA 31 & NORA Practice Questions and Answers (100% Pass) Cast iron fittings can be used in heating fuel systems? - Answer️️ -False Tank vent shall terminate - Answer️️ -Within 12 feet of the fill and visible from the fill Tanks exceeding 330 gallons must have - Answer️️ -Top supply connection Fuel return piping from an appliance shall - Answer️️ -Enter the top of the tank Oil appliances burning used oil shall only be installed - Answer️️ -In commerci...

HVAC lvl 2 Compressors 03302 (25 Questions) Test with Verified Solutions Floodback happens when what enters the crankcase of the compressor? A. Water B. Liquid refrigerant C. Vapor refrigerant D. Acid - Answer-B. Liquid refrigerant What component helps protect the compressor from floodback? A. Oversized expansion valve. B. Crankcase heater C. Motor burn out switch. D. Suction line. - Answer-B. Crankcase heater What value is used when adjusting the CPR so that the ...

ASE A1 Test Prep – Engine Repair - Questions, Answers and Explanations Technician A says that a defective harmonic balancer can cause inaccurate ignition timing readings. Technician B says that a defective harmonic balancer can cause a broken crankshaft. Who is right? A. Technician A only B. Technician B only C. Both A and B D. Neither A or B Both technicians are right. The outer ring on a defective harmonic balancer can slip, causing inaccurate ignition timing readings. A broken crankshaft c...

Oil Burner Test Questions and Answers (Graded A)Oil Burner Test Questions and Answers (Graded A)Oil Burner Test Questions and Answers (Graded A)Oil Burner Test Questions and Answers (Graded A) Max safety timing on a primary control - ANSWER-15 seconds Safety control circuits shall be - ANSWER-2-wire, one side grounded, with nominal voltage not exceeding 150v Crankcase/used oil may only be used in - ANSWER-Commercial/industrial setting. Or in a appliance specifically designed to do so.

Ca Smog Check Inspector Training Final Review (Part 2) 1. Only smoke emitted from the crankcase vent hoses (PCV System) during the inspection for visible smoke.: What constitutes a failure of the crankcase portion of the visible smoke test? 2. 10 Seconds: How long should the tailpipe and crankcase be observed during the idle portion of the Visible Smoke Test? 3. All hybrid vehicles: Which vehicles are not subject to a Visible Smoke Test? 4. More than three seconds.: How long must smoke li...

"Additives" are sometimes added to lubricating oil __________ - Hold to a minimum the oxidation of the oil A "shrink fit" collar is to be removed from a shaft. One good way to do this would be to drive out the shaft after __________ - Heating the collar only A 24-strand wick will feed to a large bearing operating at high speed MOST NEARLY the following quantity of oil, in drops per minute: - 30 A 300 horsepower stationary diesel engine running at full load for an hour uses a quantity o...

Only smoke emitted from the crankcase vent hoses (PCV System) during the inspection for visible smoke. Correct Answer-What constitutes a failure of the crankcase portion of the visible smoke test? 10 Seconds Correct Answer-How long should the tailpipe and crankcase be observed during the idle portion of the Visible Smoke Test? All hybrid vehicles Correct Answer-Which vehicles are not subject to a Visible Smoke Test? More than three seconds. Correct Answer-How long must smoke linger in o...

What procedure should be followed when valve blow-by is indicated by a hissing sound on a reciprocating engine when pulling the propeller through? - Answer-Perform a cylinder compression test to identify the faulty cylinder. What is the running valve clearance on engines equipped with hydraulic valve lifters? - Answer-Zero. When troubleshooting a running engine malfunction, what does a cold cylinder indicate? - Answer-Lack of combustion in that cylinder. What factors about the condition...

Latest Smog Check Inspector Exam CA Latest Update Questions and 100% Verified Correct Answers Guaranteed A+ What are two types of TSI (Two speed idle tests?) - Correct Answer 2500 rpm and Idle What are the two types of Acceleration Simulation mode tests? - Correct Answer 50/15 and 25/25 test What is required under visual inspection for gasoline vehicles from ? - Correct Answer All of them (Crankcase emission controls, TAC, EVAP, EGR, computers, sensors, switches, visible smoke, liquid ...