Landing flaps - Study guides, Class notes & Summaries

SkyWest Ground Flashcards (CRJ200) Questions with correct Answers When do I accomplish Originating Check? (FCMP) 1) FFOD, 2) After flight crew change, 3) Aircraft completely powered down, 4) After maintence has been performed When do I accomplish a Pre-Start Check? Every flight What duties are accomplished in the Pre-Start Check Task, Preflight Checks? 1) Airworthiness acceptance, 2) External inspection/security inspection, 3) Review dispatch for accuracy, 4) Crewmember preflig...

United Airlines B787 Aircraft General Actual Set Questions & Revised Correct Answers PASSED!! With the seat belt sign switch in the AUTO position, which of the following will cause the FASTEN SEAT BELT signs to automatically illuminate: A. When the landing gear is not up and locked. B. When the flap lever is in the Flaps 5 position or greater. C. When the cabin altitude is 10,000 feet. D. All the above. - ANSWER : D. All the above If normal electrical power is lost, cabin emergency...

Explain Captain/Dispatcher joint responsibility. - correct answer ...for the preflight planning of each flight. They determine the suitability of weather, field, traffic and airways. Either can delay a flight, but only SOC (Systems Operations Control) can cancel a flight. When is an alternate required? - correct answer --The 123 rule: within 1 hr of arrival: 2,000 ft ceiling and 3 sm vis (for domestic operations) --123+ 1 hr: 2,000ft or 1500 above the lowest IAP mins whichever is higher,...

Gleim Private Pilot FAA Knowledge Test Guide Gleim Private Pilot FAA Knowledge Test Guide What is one purpose of wing flaps? To enable the pilot to make steeper approaches to a landing without increasing the airspeed. One of the main functions of flaps during approach and landing is to: Increase the angle of descent without increasing the airspeed. What is the purpose of the rudder on an airplane? To control yaw. Which is not a primary flight control surface? A. Flaps B. Stabilat...

Jeppesen Private Pilot Stage 1 Exam Online Reviewer (2022/2023) Already Passed What action should a Pilot take when operating under VFR in a Military Operations Area (MOA)? Exercise extreme caution when military activity is being conducted The angle between the chord line of an airfoil and the relative wind is known as the angle of Attack Floating caused by the phenomenon of Ground Effect will be most realised during an approach to land when at Less than the Length of the wingspan above the s...

If a third class medical certificate was issued to a 35-year-old pilot on March 26, when will it expire? - Correct Answer-March 31, 5 years later With respect to pilot certification, which is a category and class of aircraft? - Correct Answer-Airplane; single-engine land With respect to the certification of aircraft, which are categories of aircraft? - Correct Answer-Normal, utility, acrobatic Which are currency requirements that you must meet to act as pilot in command of an airplane car...

Datum Line - ANSWER Imaginary point on the aircraft picked by the manufacturer to measure CG Arm - ANSWER Horizontal distance (in) from datum to CG CG range - ANSWER the distance between forward and aft CG position limits to retain airplane controllability Floor load limit - ANSWER The maximum weight the floor can sustain per square inch/foot as provided by the manufacturer. fuel load - ANSWER usable fuel Empty Weight - ANSWER Weight of plane excluding people and luggage Max ramp weight...

AMT Airframe O&P Questions and Answers Already Passed What are the primary materials used in aircraft airframe construction? Common materials used include aluminum alloys, titanium, composites, and steel. How does the empennage contribute to an aircraft's stability? The empennage, which includes the tail section, stabilizes the aircraft during flight and controls pitch and yaw. What are the basic components of an aircraft landing gear system? The basic components include the m...

PRIVATE PILOT EXAM PRACTICE 2024 QUESTIONS AND ANSWERS VERIFIED UPDATE What is one purpose of wing flaps? - To enable the pilot to make steeper approaches to a landing without increasing the airspeed

Private Pilot Exam Practice Questions And Revised Answers With Illustration Images What is one purpose of wing flaps? To enable the pilot to make steeper approaches to a landing without increasing the airspeed. One of the main functions of flaps during approach and landing is to: Increase the angle of descent without increasing the airspeed. What is the purpose of the rudder on an airplane? To control yaw. Which is not a primary flight control surface? A. Flaps B. Stabilator C A...