ASE Bundled Exams Questions and Answers

ASE A4 practice test Questions and answers |100% pass 2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels cou...

ASE A4 Practice Test - ASE A4 Steering and Suspension Test Prep - Test 1 Questions and Answers Raise the vehicle in the air and unload the control arms before torquing them to specifications. - Answer-All of the following are true about control arm bushings EXCEPT: A. Control arm bushings are l...

ASE A4 Steering Suspension Practice Test Questions and Answers A vehicle's front wheels have excessive positive camber on one side and excessive negative camber on the other. Which of theses is MOST likely causing this condition? - Answer-The engine cradle has shifted Technician A says the (...

ASE A5 Practice Test Questions and Answers 100% Pass 1. On a car with disc/drum brakes, the front brakes grab quickly when light pedal pressure is applied. This problem could be caused by a bad: A. proportioning valve B. pressure safety switch C. metering valve D. residual check valve - ...

ASE A1 - Practice Test (Section A) Questions and Answers 1. an engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A only B on...

ASE Automotive Parts Specialist (P2) Questions and Answers

ASE B-5 Mechanical/Electrical Exam Questions and Answers A vehicle is brought in with a bent subframe. Technician A says to section the subframe. Technician B says the subframe should not be repaired and must be replaced. Who is right? A, B, Both, or Neither - Answer-Technician B only The subfr...

ASE B6 Test - Damage Analysis & Estimating Exam Questions and Answers What is the difference between a unitized frame and a uni-body? - Answer-There is no difference. In a uni-body or unitized vehicle, the frame and body are incorporated into a single welded structure. Should exhaust damaged sy...

ASE BRAKES Exam #1 Practice Questions and Answers A - Answer-A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - Answer-A vehicle is equipped with a hydro-...

ASE Brakes T4 Practice Test #1 Questions and Answers Which of the following could cause the brakes on a truck to wear too fast? A. Glazed Drums B. Wrong linings installed C. Low air pressure in the service tanks D. Governor cut-out pressure too high - Answer-Answer A is incorrect. Glazed drum ...

ASE Certification Exam Questions and answers Both b and c - Answer-Coolant should be tested for ________. Proper color Freezing point (temperature) Specific Gravity Both b and c Both technician a and b - Answer-Two technicians are discussing a compression test. Technician A says that the eng...

ASE Certification Practice Test - Auto Electrical Systems Questions and Answers 1. Technician A says an automotive power mirror system's horizontal control motor operates the up-and-down movement of the mirror glass.Technician B says an automotive power mirror system's gear reduction decre...

ASE certification study guide with complete solutions Spark plugs are being replaced on a v6 engine. Which of the following should be performed before removing the boot? - Answer-Twist the boot 1/2 a turn Technician A days that a positive crankcase ventilation (pvc) system reduces vehicle emissi...

ASE Collision Repair and Refinish Tests Questions and Answers Painter A says that metal conditioner should be used under plastic filler to assure proper adhesion. Painter B says that metal conditioner should be used under plastic filler only if rust is present. Who is right? (A) A only (C) Bot...