ASNT VT LEVEL II QUESTIONS WITH CORRECT ANSWERS

1. Localized education in an area of a bolt that is under overload conditions is referred to as? A. Sizing B. Necking Down C. Erosion D. Elongation CORRECT ANSWER b 2. The least common location for fastener failure is? A. In the head to shank fillet. B. Throughout the first thread inside the nut on threaded fasteners. C. In the mid grip. D. At the transition from the thread to the shank. CORRECT ANSWER c 3. Discontinuities that are produced during the hot or cold working of the ingot into rod or bar to make studs are called? A. Inherent discontinuities. B. Primary processing discontinuities. C. Secondary processing discontinuities. D. Service-induced discontinuities. CORRECT ANSWER b 4. Service-induced discontinuities in bolting systems may be produced by? A. Vibration. B. Over-tensioning C. Corrosion D. All of the about CORRECT ANSWER d 5. The fillet weld size is based on the? A. Effective fillet weld throat. B. Length of fillet weld. C. Theoretical throat. D. Length of fillet weld leg. CORRECT ANSWER d 6. A convex weld surface? A. Curves inward. B. Curves outward. C. Contains a hollow. D. Does both a and c above. CORRECT ANSWER b 7. During the solidification of metal, a hole produced due to escaping gases is called a? A. Burst B. Cold shut.