PA State Auto Inspection Already Graded A

PA State Auto Inspection Already Graded A Stickers shall be kept where? Kept under lock and key in a safe place What is done with any unused stickers? Keep them until the QAO comes around. You get a 75% refund on unused stickers. First offense of faulty inspection and improper inspection? Category 1 violation. 2 months suspension. When checking registration or VIN what do we look for, and what if there's a problem? VIN number and license plate must agree with registration card. Allowed to have one number off or two numbers transposed (out of order) if the owner proves forms have been sent to Penn DOT. VIN plate can't be loose, defaced, or missing. If there is a problem owner must get a corrected registration or show that proper forms have been sent to Penn DOT. What do you check glazing for? Approved safety glass must be in every window and it must be permanently labeled. See Appendix C(f) Non transparent material or glass etchings may not obstructs the drivers view and may not be higher than 3-1/2 inches from the bottom of any side or rear window. Glass may not be shattered, broken or have sharp edges. No defects in the acute area or the critical area or the windshield. Louvers can't obstruct driver's vision. Dual side mirrors are required when using sunscreen or louvers. What area of the windshield can there be no imperfections? The acute area. (8-1/2 X 5-1/2) List all the ways to check the wipers. Speed at manufactures specs or at least 45 cycles per minute Blades can't be torn or smear or streak after 5 cycles. Must have all wipers Wipers must reset to rest position. Washer system working on cars/light trucks newer than 1968. What do you check the doors and trunk lid for? Must be original equipment or same type. Must close securely. List all the ways to check mirrors. Mirrors can't be cracked, discolored or broken., Mirrors must hold adjustment. Can't be loose. Cars with louvers and sunscreens must have 2 outside mirrors (19-1/2 square inches each). No junk hanging from rear view mirror. What's the rule for fender flares? May not exceed 3 inches. What do you check floor for? Must be able to support weight of people and cargo. No holes allowed. What is the bumper height for a car and a truck. Must be as strong as and no longer than original bumper. Can't be broken or torn. Wood planks on service trucks (wreckers) only. Height- passenger vehicles 16-20 inches above ground MPVs, SUV's and light trucks 16-30 inches above ground. Turn signals should have a frequency of flash between __________ flashes per minute. 60 - 120 flashes per minute. What are the guidelines for back up lights? Must turn off when not in reverse OR have a dash indicator light or audible warning. What are the guidelines for broken lenses? Will not pass if white light shows through. List three reasons for rejecting shocks. Missing shocks Mounts or mounting bolts broken Severe leakage. Slight dampness OK What's the minimum steering wheel size? 13 inches The horn should be heard at least ________feet away. 200 feet What do we look for when checking the brake pedal? Can't go down more than 80% of total travel. Can't fade when vehicle is stopped. (bleed by in master cylinder) No excessive friction in linkage. Can't be missing the rubber pedal pad. What's the min. brake specs for Bonded?_______Riveted?_________ Bonded 2/32 Riveted 1/32 What do we check brake hoses for? Make sure they aren't disconnected, don't leak, flattened or Restricted, dry rot (cord showing) List the items for interior inspection. Steering wheel free play Steering gear box Steering column Proper size steering wheel Proper turning Flexible steering coupler Indicator lamps for high beam, turn signals. Horn- must be stock type Brake pedal travel Brake pedal fade Brake pedal linkage Brake pedal pad Seats- DRIVERS seat and back must be firmly attached No springs sticking out of DRIVER'S seat Seat adjustment must work Seat belts in good condition ( if originally equipped) Rear view mirror- no cracks or discoloration Rear view mirror- must hold adjustment. No junk hanging on it. Describe steering "Lock to Lock" Turning the front wheels as far as they go from one side to the other. "Stop to Stop" Describe the "1/4 inch Play Test" Used to check tightness of steering linkage and gearbox. Raise front wheels off the ground. Have someone hold on the brakes to eliminate bearing play. Wiggle the front tires. No more than 1/4 play allowed measured at the outside of the tire. What do we check motor mounts for? Reject if broken. List all items for under hood inspection. Hood latch in good working order. Must be double latched.