Texas State Inspector Safety cert.Questions With Correct Answers!!

One of the required procedures in the inspection of the steering is: - Answer-Turning the steering wheel from full left to full right Conventional brakes or non-power brakes must have a minimum pedal reserve of: - Answer-2 inch Any tire with wear bar indicators would be rejected for the following reason: - Answer-Tread wear indicators contact the road on any two adjacent major grooves in the center of the middle of the tire LED tail lamps may have no more than ______ of diodes malfunctioning to pass inspection. - Answer- 50% When performing a road test on the service brakes, a truck weighing over 10,000 lbs GVW (this would include larger trucks but not truck-trailer combinations) should be driven at a speed of 20 mph and should stop within: - Answer-40 feet The vehicle owner/operator should be present when the inspector is checking CNG tank located in the trunk of the car. - Answer-True Glass coating or sun screening materials on windshield may not extend down past the AS-1 line or more than ____ inches, whichever is closer to the top of the windshield: - Answer-5 inches Brakes would be rejected if: - Answer-There is obvious metal to metal contact when brakes are applied. When issuing a Vehicle Inspection Report to a vehicle, the VIN will be taken from the: - AnswerVehicle Proof of financial responsibility is not required on motor vehicles prior to the model year 1988. - Answer-False When is a vehicle required to be inspected for seat belts? - Answer-Anchorages were part of the manufactures original equipmentThe turn signal selector switch must lock in the proper position when applied on: - Answer-All vehicles A truck or trailer is required to have clearance lamps and side marker lamps if the total width of the vehicle is: - Answer-80 inches or more In order to pass inspection, tires must have a tread depth of at least ___ in the two center adjacent major grooves. - Answer-2/32 inch A parking brake is required to be inspected on all cars and trucks beginning with the model year: - Answer-1960 The exhaust system includes the following: - Answer-Manifold, Exhaust Pipe, Muffler(All of the above) A muffler with a hole which has been patched: - Answer-Will be rejected Fluid level in the brake master cylinder must not be more than how many inches below the top of the reservoir? - Answer-1 inch When using a window tint meter, the amount of light transmission cannot be less than? - Answer- 25% When required, safety guards or flaps must be what width? - Answer-At least as wide as the tires they are protecting. Sun screening or glass coating material will be an item of inspection on the following vehicles: - Answer-All vehicles regardless of year A motor vehicle originally equipped with a catalytic converter will be rejected if the catalytic converter has been removed or disconnected beginning with year model - Answer-1984 When checking operation of the headlamps, a vehicle will be rejected if: - Answer-Physical damage would obviously cause a handlamp beam to fail to sufficiently illuminate the roadway ahead of the vehicleA license plate lamp must be white in color and rejected for: - Answer-Mounting, Shoddy wiring, Lamp lens is broken or does not fit properly(All of the above) Mirrors would be rejected if: - Answer-Reflecting surface is cracked, peeled, or tarnished, mirror interferes with driver's forward vision, mirror does not afford a clear view to the rear(Any of the above) What color tail lamps are required to pass inspection? - Answer-Red