Package deal
ABSA EXAM PACKAGE DEAL WITH COMPLETE SOLUTIONS GRADED A+
ABSA EXAM PACKAGE DEAL WITH COMPLETE SOLUTIONS GRADED A+
[Show more]ABSA EXAM PACKAGE DEAL WITH COMPLETE SOLUTIONS GRADED A+
[Show more]Which type of oil produces higher fluid friction? 
Select one: 
a. High viscosity oil 
b. Low viscosity oil 
c. Synthetic oils 
d. Fixed oils - Answer-a 
A counter-flow cooling tower _____________ than a crossflow cooling tower. 
Select one: 
a. requires less fan power 
b. has a lower pressure drop ...
Preview 4 out of 43 pages
Add to cartWhich type of oil produces higher fluid friction? 
Select one: 
a. High viscosity oil 
b. Low viscosity oil 
c. Synthetic oils 
d. Fixed oils - Answer-a 
A counter-flow cooling tower _____________ than a crossflow cooling tower. 
Select one: 
a. requires less fan power 
b. has a lower pressure drop ...
(4-081-1.16) The output voltage of a shunt DC generator is varied by adjusting the: 
Select one: 
a. Pole piece air gaps 
b. Output current 
c. EMF 
d. Field rheostat - Answer-d 
(4-085-1.11) The Bourdon tube is often shaped in the form of a "C", having an arc span of about: 
Select one: 
a. 270 d...
Preview 4 out of 39 pages
Add to cart(4-081-1.16) The output voltage of a shunt DC generator is varied by adjusting the: 
Select one: 
a. Pole piece air gaps 
b. Output current 
c. EMF 
d. Field rheostat - Answer-d 
(4-085-1.11) The Bourdon tube is often shaped in the form of a "C", having an arc span of about: 
Select one: 
a. 270 d...
Lowest boiling point of water is at? 
a. 3000m above the sea level 
b. Just below sea levelc. 
at 1000m above sea level 
d. at 101.3kPa - Answer-a. 3000m above the sea level 
Efficiency of an electrostatic precipitator is: 
a. 75% 
b. 60% 
c. 90% 
d. 99.9% - Answer-d. 99% 
Non-Return stop valves are...
Preview 4 out of 34 pages
Add to cartLowest boiling point of water is at? 
a. 3000m above the sea level 
b. Just below sea levelc. 
at 1000m above sea level 
d. at 101.3kPa - Answer-a. 3000m above the sea level 
Efficiency of an electrostatic precipitator is: 
a. 75% 
b. 60% 
c. 90% 
d. 99.9% - Answer-d. 99% 
Non-Return stop valves are...
What must be located outside a Class T machinery room? 
Select one: 
a. Spare flashlights 
b. Disposable coveralls 
c. Machinery shut off switch 
d. Light switches - Answer-c 
Degradation of heat transfer fluid of a hot oil system will begin to occur if: 
Select one: 
a. The oil filter is not servic...
Preview 4 out of 43 pages
Add to cartWhat must be located outside a Class T machinery room? 
Select one: 
a. Spare flashlights 
b. Disposable coveralls 
c. Machinery shut off switch 
d. Light switches - Answer-c 
Degradation of heat transfer fluid of a hot oil system will begin to occur if: 
Select one: 
a. The oil filter is not servic...
One of the legal responsibilities of the engineer during an inspection is: 
Select one: 
a. To notify the Workers Compensation Board of the inspection 
b. Point out any known or suspected defects to the inspector 
c. To have at least two staff members present at all times 
d. To be in possession of ...
Preview 4 out of 43 pages
Add to cartOne of the legal responsibilities of the engineer during an inspection is: 
Select one: 
a. To notify the Workers Compensation Board of the inspection 
b. Point out any known or suspected defects to the inspector 
c. To have at least two staff members present at all times 
d. To be in possession of ...
Packaged watertube boilers capacities range from? 
a. 2300 kg to 65000 kg per hour 
b. 500 kg to 100 mg per hour 
c. 15 psi to 15000 kg per hour 
d. 65000 to 100000 kg per hour - Answer-A 
The main advantage of the packaged boiler is its 
a. small size 
b. compact design 
c. low cost 
D. quality ste...
Preview 4 out of 115 pages
Add to cartPackaged watertube boilers capacities range from? 
a. 2300 kg to 65000 kg per hour 
b. 500 kg to 100 mg per hour 
c. 15 psi to 15000 kg per hour 
d. 65000 to 100000 kg per hour - Answer-A 
The main advantage of the packaged boiler is its 
a. small size 
b. compact design 
c. low cost 
D. quality ste...
Where are the return openings located regarding air distribution systems? - Answer-Return air openings 
are located on inner walls. 
The minimum temperature of the water used in a hydrostatic test of a boiler cannot be less than what 
temperature? - Answer-20 degrees Celsius 
Which of the following ...
Preview 4 out of 31 pages
Add to cartWhere are the return openings located regarding air distribution systems? - Answer-Return air openings 
are located on inner walls. 
The minimum temperature of the water used in a hydrostatic test of a boiler cannot be less than what 
temperature? - Answer-20 degrees Celsius 
Which of the following ...
Temporary hardness in feedwater is caused by: 
Select one: 
a. Magnesium sulphate 
b. Calcium carbonate 
c. Magnesium bicarbonate 
d. Sodium nitrate - Answer-c 
What is the recommended boiler water pH for wet layup? 
Select one: 
a. 10 
b. 12 
c. 7.5 
d. 7 - Answer-a 
A photoelectric flame scanner: ...
Preview 4 out of 43 pages
Add to cartTemporary hardness in feedwater is caused by: 
Select one: 
a. Magnesium sulphate 
b. Calcium carbonate 
c. Magnesium bicarbonate 
d. Sodium nitrate - Answer-c 
What is the recommended boiler water pH for wet layup? 
Select one: 
a. 10 
b. 12 
c. 7.5 
d. 7 - Answer-a 
A photoelectric flame scanner: ...
Warm Air Heating System Equipment 
In a warm air heating system the cold air return registers 
are located 
a) in exterior walls 
b) in interior locations 
c) under windows 
d) in floors 
e) in ceilings - Answer-B 
The major disadvantage of an electric resistance coil furnace 
for warm air heating i...
Preview 4 out of 211 pages
Add to cartWarm Air Heating System Equipment 
In a warm air heating system the cold air return registers 
are located 
a) in exterior walls 
b) in interior locations 
c) under windows 
d) in floors 
e) in ceilings - Answer-B 
The major disadvantage of an electric resistance coil furnace 
for warm air heating i...
Internal ____ is not required for dynamic type compressors. 
seals 
lubrication 
pressure monitoring 
corrosion monitoring 
temperature monitoring - Answer-b 
Low pressure or high pressure are the two primary classifications of ____. 
centrifugal pumps 
sump pumps 
boilers 
draft fans 
pressure cont...
Preview 4 out of 427 pages
Add to cartInternal ____ is not required for dynamic type compressors. 
seals 
lubrication 
pressure monitoring 
corrosion monitoring 
temperature monitoring - Answer-b 
Low pressure or high pressure are the two primary classifications of ____. 
centrifugal pumps 
sump pumps 
boilers 
draft fans 
pressure cont...
When applying to write a Power Engineer certificate of competency examination, the candidate must: 
Select one: 
a. Undergo mandatory drug testing 
b. Hold the next lower class of qualification 
c. Pass a criminal records check 
d. Pass both a written and oral examination - Answer-b. Hold the next l...
Preview 4 out of 72 pages
Add to cartWhen applying to write a Power Engineer certificate of competency examination, the candidate must: 
Select one: 
a. Undergo mandatory drug testing 
b. Hold the next lower class of qualification 
c. Pass a criminal records check 
d. Pass both a written and oral examination - Answer-b. Hold the next l...
1. Which is not considered part of a sterile field? - Answer-Gloves of sterile person who has folded his 
arms 
2. The presence of only one living microorganism means an object is: - Answer-Contaminated 
3. Which statement concerning masks is not true? - Answer-Ties may be tied crisscross on top of ...
Preview 4 out of 32 pages
Add to cart1. Which is not considered part of a sterile field? - Answer-Gloves of sterile person who has folded his 
arms 
2. The presence of only one living microorganism means an object is: - Answer-Contaminated 
3. Which statement concerning masks is not true? - Answer-Ties may be tied crisscross on top of ...
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
You can quickly pay through credit card for the summaries. There is no membership needed.
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Stuvia is a marketplace, so you are not buying this document from us, but from seller PatrickKaylian. Stuvia facilitates payment to the seller.
No, you only buy these notes for £14.85. You're not tied to anything after your purchase.
4.6 stars on Google & Trustpilot (+1000 reviews)
79223 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now