Bonent Exam (2023/2034) Graded A

Bonent Exam (2023/2034) Graded A How long is 1% PAA stable after it is mixed? 1% PAA expires 24 hours after itis mixd. However, the solution must be mixed fresh daily before starting reuse activities. What would you do if you ran out of chemical or disinfectant? Reuse must be discontinued. Teammates are not allowed to transport Renalin. What would you do if you acccidentally added too much dialysis quality ater or Renalin 100 to the 1 Liter graduated cylinder when mixing 1% PAA solution? The solution must be discarded and re-mixed. What would you do if you noticed any of the port caps had popped off of the reprocessed dialyzer during storage? The dialyzer must not be used. The dialyzer must be tested using a a Residual PAA test strip, and then be reporocessed again without adding a use if the strip result is 100ppm or greater. What would you do if a teammate came into the reuse room to get a reprocessed or preprocessed dialyer that had not dwelled for at least 11 hours? The dialyzer must not be used for patient treatment unless it has dwelled for a minimum of 11 hours. What would you do if a teammate came into the reuse room without wearing a gown, gloves and face protection Remind the teammate that they must wear the required PPE at all times while in reuse room What PPE do you wear in the reuse room, and why? Reuse gown, gloves and full face protection. This PKPE must be worn at all times while in the reuse room to protect the teammate from blood and chemical exposure. What is the required temp of the reuse refrigerator? 36-50 degrees F What is the required temp of the reuse room and reprocessed dialyzer storage? 59-75 degrees F What is the required temp of the reuse chemical storage area? Above 32-75 degrees F What do you do if any of the temps are out of range? Notify the FA, DRTC/Reuse Lead, and Biomed teammate. What is the required Renatron test volume when performing the calibration cell volume check? 67-73mL What is the volume of the calibration cell? A volume of 70mL What is required dynamic water pressure to the Renatron? 20-55psi When is the dynamic water pressure to the Renatron observed? In step 4 on the Renatron when performing the calibration verification during the startup procedure What What is the required static water pressure