CCT EXAM STUDY GUIDE EXAM/60 Q’S AND
A’S
Which method is the fastest way to recover a software version that supports
a USB flash port on a Cisco device? - -copy command with USB memory
-Which protocol does TFTP typically use for transport - -UDP
-What is the correct IPv6 Address notation? - -
2001:0DB8:130F:D000:D00B:700D:DODD:140B
-Which two statements about Telnet and SSH are true? - -SSH is a protocol
that provides a secure remote access connection.
A Telnet network management connection is dropped when a router reboots.
-Which address facillitates the routing of packts over an IP network? - -
Network
-Which two addresses can be assigned to a host computer? - -
192.168.10.15
10.1.1.20
-What are two components of a WAN Connection? - -CSU/DSU
Router
-Which device is a DTE Device? - -Router
-Which layer of the OSI model defines how data is formatted for
transmission and how access to the physical is connected. - -Data link
-Which command shows the status of power supplies and sensor
temperatures? - -show environment
-What are two standard fiber-optic connectors? - -Luce
subscriber
-What type of physical connector does a Gigabit Ethernet port typically use?
- -RJ-45
-Which two pairs of LAN Ethernet devices use an RJ-45 straight-through
cable? (Choose two.) - -switch-to-router
Switch-to-server
-Which two features are assocaited with single-mode fiber-optic cable?
(Choose two.) - -Consists of a single strand of glass fiber
, Carries a higher bandwidth than multi-mode fiber
-Refer to the exhibit. Which two statements about the hardware components
are true? - -cable 3 is a USB type a port.
cable 2 is a USB 5-pin mini USB tybe B to USB type A console cable
-Which type of transciever module is used for 40 gigabit Ethernet
connectivity? - -QSFP+
-What is the line speed of a DSL in North America? - -64 kbps
-Which two ports on a laptop are used to gain console access to a Cisco
Switch? - -DB-9
USB
-Which two statements about a SmartJack are true? - -It provised signal
conversion.
It regenerates the signal to compensate for signal degradation from line
-The colored wires at one end of a cable are in reverse sequence to the
wires at the other end. Which type of cable? - -crossover
-Which Cisco CPAK 100GBASE module supports Multimode fiber cable? - -
Cisco CPAK-100G-SR4
-Which two sets of pins are looped on an RJ-45 56k loopback plug? - -pins 2
and 5
pins 1 and 4
-How many pairs of copper wire odes a UTP cable have? - -4
-Which two Cisco Nexus 3400 Series switches support 400-Gbps Ethernet
ports? - -Cisco Nexus 3432D-S
Cisco Nexus 3408-S
-Which type of memory stores the configuraten of a router or switch by
default? - -RAM
-Which two command identify the serial number of a Cisco router? - -show
inventory
show version
-Which two commands set the configurate register value? - -
rommon>configreg 0x2102
router(config)#config-register 0x2102
A’S
Which method is the fastest way to recover a software version that supports
a USB flash port on a Cisco device? - -copy command with USB memory
-Which protocol does TFTP typically use for transport - -UDP
-What is the correct IPv6 Address notation? - -
2001:0DB8:130F:D000:D00B:700D:DODD:140B
-Which two statements about Telnet and SSH are true? - -SSH is a protocol
that provides a secure remote access connection.
A Telnet network management connection is dropped when a router reboots.
-Which address facillitates the routing of packts over an IP network? - -
Network
-Which two addresses can be assigned to a host computer? - -
192.168.10.15
10.1.1.20
-What are two components of a WAN Connection? - -CSU/DSU
Router
-Which device is a DTE Device? - -Router
-Which layer of the OSI model defines how data is formatted for
transmission and how access to the physical is connected. - -Data link
-Which command shows the status of power supplies and sensor
temperatures? - -show environment
-What are two standard fiber-optic connectors? - -Luce
subscriber
-What type of physical connector does a Gigabit Ethernet port typically use?
- -RJ-45
-Which two pairs of LAN Ethernet devices use an RJ-45 straight-through
cable? (Choose two.) - -switch-to-router
Switch-to-server
-Which two features are assocaited with single-mode fiber-optic cable?
(Choose two.) - -Consists of a single strand of glass fiber
, Carries a higher bandwidth than multi-mode fiber
-Refer to the exhibit. Which two statements about the hardware components
are true? - -cable 3 is a USB type a port.
cable 2 is a USB 5-pin mini USB tybe B to USB type A console cable
-Which type of transciever module is used for 40 gigabit Ethernet
connectivity? - -QSFP+
-What is the line speed of a DSL in North America? - -64 kbps
-Which two ports on a laptop are used to gain console access to a Cisco
Switch? - -DB-9
USB
-Which two statements about a SmartJack are true? - -It provised signal
conversion.
It regenerates the signal to compensate for signal degradation from line
-The colored wires at one end of a cable are in reverse sequence to the
wires at the other end. Which type of cable? - -crossover
-Which Cisco CPAK 100GBASE module supports Multimode fiber cable? - -
Cisco CPAK-100G-SR4
-Which two sets of pins are looped on an RJ-45 56k loopback plug? - -pins 2
and 5
pins 1 and 4
-How many pairs of copper wire odes a UTP cable have? - -4
-Which two Cisco Nexus 3400 Series switches support 400-Gbps Ethernet
ports? - -Cisco Nexus 3432D-S
Cisco Nexus 3408-S
-Which type of memory stores the configuraten of a router or switch by
default? - -RAM
-Which two command identify the serial number of a Cisco router? - -show
inventory
show version
-Which two commands set the configurate register value? - -
rommon>configreg 0x2102
router(config)#config-register 0x2102
