NICET LEVEL III WATER BASED LAYOUT Exam Questions And Answers Updated 2024/2025

©THESTAR EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 1 | P a g e NICET LEVEL III WATER BASED LAYOUT Exam Questions And Answers Updated 2024/2025 General Conditions - answerWhat is not included in the technical specification? •contract •specifications •contract drawings - answerBid documents include? General Conditions - answerCodes, standards, Authority Having Jurisdiction (AHJ), clean-up, safety requirements, barricades, fencing, insurance and bond requirements, ect. Supplementary Conditions - answerAddendums, time schedules, working days allowed, delay agreements, payment schedules Construction Specifications Institute (CSI) - answerSpecifications typically use what format? Contractors - answerConstruction manager concept is when the owner contracts with the construction manager who oversees ____________ working on the project Design-Build Concept - answerSometimes referred to as a turn-key type agreement or contract? general contractor - answerMultiple Prime Contractor Method has the intent is eliminate the middleman __________ __________. •architectural/structural contractor •mechanical contractor •electrical contractor - answerMultiple prime contractor method involve more than one prime contractor which consist of? ©THESTAR EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 2 | P a g e •federal government •general services administration (GSA) •large companies - answerWho commonly uses the multiple prime contractor method? Owner, architect, general contractor, subcontractor - answerTraditional method contract uses the typical chain of command which is? •open bid method •bid-by invitation procedure •direct contractor selection - answerGeneral contractors can be chosen in a number of different ways which is? General category and supplementary conditions - answerContract conditions is divided into two categories which is? Addendum - answerChanges to the contract or other modifications. •up-front payments •progress payments •lump sum - answerTypes of payment schedules are? Bidding requirements, sample forms, conditions of the contract and specifications, including general conditions and supplementary conditions - answerWhat comprises the project manual? •contract itself •contract conditions •specifications •drawings - answerContract documents include: Preliminary, bid, approval, construction, as-built - answerDrawings have different stages which are? Request for proposal (RFP) - answerOftentimes a project will begin with a _________. •certified value specialist •owner's representatives •designers and consultants ©THESTAR EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 3 | P a g e •the construction team •cost estimator •building management staff •third-party (independent) reviewers - answerValue-engineering team typically consist of? •Information gathering •brainstorming •analysis •development •recommendations - answerValue-engineering typically goes through phases which are? Planning stage - answerAt what stage does value-engineering provide the most benefit? Value = Function / Cost - answerValue-engineering equation is: Low cost and high value - answerValue-engineering cost vs value goal is? Giving careful consideration to all options, without sacrificing the project's goals. - answerValue-engineering of a project involves: Request for Information (RFI) - answerDiscrepancies between the plans and specifications should be resolved using a? 36 inches - answerMinimum distance between the deflector and the top of the storage shall be? 8 foot on center - answerThe minimum distance control modes sprinklers can be spaced apart is? 12 inches - answerThe minimum distance an upright control mode sprinkler shall be permitted to be offset horizontally from the pipe is? 12 inches - answerThe minimum distance upright control mode sprinkler shall be located above the centerline of the pipe for pipe greater than 4 inch nominal in diameter? 8 foot - answerThe minimum distance ESFR sprinklers can be spaced apart is? 12 sprinklers located on 3 branch lines - answerHow many sprinklers are required to be calculated on ESFR systems?