NACE CIP1 & CIP2 (Level 1 & Level 2) Exams STUDY GUIDE BUNDLE WITH COMPLETE SOLUTIONS 2023/24

What is the cause of chalking in epoxy coating - UV or radiation exposure What is polymerization cured coating? - Two parts mixed together just prior to use Examples of non-convertible coatings - 1. Chlorinated rubber 2. Vinyl 3. Acrylic 4. Bituminous Non-convertible curing def. - No chemical ch...

Dew point is the temperature at which - condensation occurs. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of ac...

How is the process of steel corrosion ALWAYS described? - electrochemical Based on the galvanic series presented in the NACE CIP Level 1 Manual, which three can be used effectively as galvanic anodes for carbon steel? - zinc, aluminum, magnesium A decrease in temperature will generally cause the...

NACE #1/SSPC-SP5 - WHITE METAL BLAST CLEANING. When viewed without magnification the surface shall be free from visible oil, grease, dust dirt, mill shcale, rust , coating, oxides, corrosion products and other foreign matter. NACE #2/SSPC-SP 10 - NEAR WHITE METAL BLAST CLEANING. When viewed with...

▪ Dew point is the temperature at which condensation occurs. ▪ You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred cour...

Describe what the characteristics of a heavy flash rusted surface are. 7-5 - Rust that is loosely adherent, easily comes of, & leaves significant marks on a cloth that is lightly wiped over the surface. Describe what the characteristics of a moderate flash rusted surface are. 7-5 - Rust that is ...

(NV) - • Non-visible contamination (VC) - • Visible surface cleanliness NACE No. 5/SSPC-SP 12 - describes the use of a high-energy water stream to strip off existing coatings and remove contaminants on a substrate being prepared prior to coatings application. When compared to abrasive bla...

High-Voltage AC Holiday Detector - This uses a 110 V or 220 V power supply. The AC detector is based on the principle of the Tesla coil and does not use a ground wire. The probe emits a blue corona, which is attracted to any ground. High-Voltage Constant Current DC Holiday Detector - This instrum...

Describe passivation - Passivation is the formation of a protective oxide Film on the surface reducing its chemical activity and its ability to corrode Describe the following factors and how they affect corrosion - Oxygen: oxygen increases the rate of corrosion temperature Temperature: corrosion...

Describe air turns - eliminates air stratification. 1-2 Turns is sufficient Below what RH does corrosion virtually cease? - 40% 2 ways to reduce RH of boundary layer- - increase surface temp & dehumidification 2 types of dehumidification equipment: - refrigerant & desiccant Benefits of dehumidi...