Auto mechanics Test Questions with 100% correct answers (latest update)

NATEF certifies automotive: A dealerships. B independent garages. C technicians. D training programs. D All of these are ASE certifications except: A automatic transmission/transaxle. B engine repair. C service and maintenance. D suspension and steering. C Which part is most likely the problem if a light does not come on during an instrument panel bulb check? A bulb B fuse C sender D switch A What organization certifies automotive technicians? A ASE B AYES C NATEF D OSHA A Carquest, NAPA, and Jiffy Lube are examples of: A fleets. B franchises. C dealerships. D specialty shops. B ASE tests and certifies automotive: A dealerships. B independent garages. C professionals. D training programs. C Which is an ASE certification? A general maintenance B brakes C tire and wheel D service B What organization accredits automotive programs? A ASE B EPA C NATEF D OSHA C Which engine oil has the best lubricating properties? A conventional oil B crude oil C plain oil D synthetic oil D Which color is the primary brake warning light on the dash of cars and trucks? A blue B green C red D yellow C When torquing lug nuts on a vehicle, which pattern should one use? A side-to-side pattern B up-and-down pattern C star pattern D circular pattern C Where is a fire evacuation route located? A beside classroom door B main office C EPA guidelines D SDS book A Technician A says an ABS will pulsate the brakes during hard stops. Technician B says ABS brakes are found only on vehicles that have been imported. Who is right? A A only B B only C Both A and B D Neither A nor B A In case of a fire, where would a student find out where to go? A call a parent for directions B check the owner's manual found in the shop C look for a map posted by the door D refer to the back page of the student handbook C What does the term ANSI stand for? A Automotive National Safety Institute B American National Standards Institute C American National Subjects Institute D Automotive National Standards Index B What is the risk of wearing a ring on one's hand while working on a vehicle? A It causes a distraction. B It causes an electrical burn. C It causes a chemical burn. D It causes carpal tunnel syndrome. B Before servicing the supplemental restraint system, what should a technician do as a safety precaution? A cut the wires B disarm the system C probe wires with a test light D remove the airbag B Technician A says wearing a long necklace in the shop is a good safety practice. Technician B says long hair is acceptable while working around moving engine parts. Who is right? A A only B B only C Both A and B D Neither A nor B D Who is allowed to read safety data sheets? A everyone B staff only C students only D teachers A What poisonous gas comes from the exhaust of a vehicle? A argon B carbon dioxide C carbon monoxide D nitrogen C Jack stands should be placed under lifted vehicles to prevent the vehicles from: A falling. B leaning. C raising. D rolling. A A chemical has spilled on a student in the shop. What is the name of the document that outlines the first aid action needed? A ASE B RSD C SDS D UPS C What is the first step when one gets a foreign object in one's eye at school? A have a friend try to remove the object B flush the eye immediately C have the teacher try to remove the object D flush the eye when one gets home B An SRS warning light is displayed on the vehicle instrument cluster. What does this light represent? A bad airbag B bad oxygen sensor C blown light bulb D low air pressure A Technician A says mopping up a spill is a good safety practice to use in the shop. Technician B says leaving one's workstation a mess is a good safety practice to use in the shop. Who is right? A A only B B only C Both A and B D Neither A nor B A What do the yellow-painted areas on a shop floor represent? A caution areas B eyewash station locations C areas with a first aid kit D eye protection not required A Which part of a vehicle is an acceptable lifting point? A floorboard B oil pan C pinch weld D transmission pan C