NCCER Module 9 (Introduction to Materials Handling) Graded A+

NCCER Module 9 (Introduction to Materials Handling) Graded A+ A ____ refers to the amount that can be transported at one time by a machine or vehicle. ️Load Before lifting any material, you should check for protruding ____, wires, or sharp edges. ️Nails The correct procedure for lifting is: lift with your ____, maintain a straight ____, and keep your ____ up. ️Legs, back, head Transporting a load that is ____ and ____ can cause difficulties. ️Long, protruding When managing cables and a pull system, it is acceptable to utilize a ____ ____ rope. ️Low-stretch Before using a ____ handling device, you must ____ it. ️Materials, inspect To ____ the center of gravity when moving materials, you should always position the ____ load at the ____. ️Lower, heaviest, bottom When ____ materials on an incline or decline, it’s important to ensure the ____ does not ____ the labeled capacity. ️Carting, load, exceed ____ ____ are designed with a rotating table surface and/or spikes for better ____. ️Roller skids, grip A ____ employs the force applied through a lever, screw, or hydraulic press to lift heavy objects. ️Jack To operate ____ materials-handling equipment, you must be ____, certified, and ____. ️Motorized, trained, authorized An ____ ____ is utilized for lifting and transporting heavy loads on a smooth surface. ️Industrial forklift The ____ of the fall zone for a forklift is ____ the height of the ____ being lifted. ️Diameter, twice, load When using ____ signals, you must maintain ____ ____ with the operator. ️Hand, eye contact An ____ that carries workers and ____ to an upper floor is classified as a ____ in terms of materials handling. ️Elevator, tools, load