1: If an object is neutrally buoyant (does not sink or float) in fresh water, the same object placed into salt water would
A sink.
B either sink or float.
C do nothing.
D float. correct answers D float.
Salt water is heavier than fresh water because it has dissolved minerals in it. This me...
Padi Final || A Verified A+ Pass.
1: If an object is neutrally buoyant (does not sink or float) in fresh water, the same object placed
into salt water would
A sink.
B either sink or float.
C do nothing.
D float. correct answers D float.
Salt water is heavier than fresh water because it has dissolved minerals in it. This means it causes
more upward force (buoyancy) on an object. An object that is neutrally buoyant in fresh water
would float in salt water because there is greater upward force. See Being a Diver I - Buoyancy
and Controlling Buoyancy.
2: I blow up a balloon, tie it off, and take it to the bottom of the swimming pool. What will
happen to the balloon and the air inside it?
A The balloon will get bigger and the air inside the balloon will be less dense (molecules move
further apart).
B The balloon will get smaller and the air inside the balloon will be more dense (molecules move
closer together).
C The balloon will get bigger and the air inside the balloon will be more dense.
D The balloon will get smaller and the air inside the balloon will be less dense. correct answers
B The balloon will get smaller and the air inside the balloon will be more dense (molecules move
closer together).
As water pressure increases, the volume of an air space will decrease. This causes the density of
the air inside to increase and air molecules are pushed closer together. The balloon would get
smaller and the air density inside would be greater. See Being a Diver I - Water Pressure and Air
Volume Effects.
3: I turn a glass upside down, trap the air in it by putting it in water, and then I take the glass
down to 10 metres/33 feet. The air space would
A become half the size it was at the surface.
B not change in size.
C become 1/3 the size it was at the surface.
D become 2/3 the size it was at the surface. correct answers A become half the size it was at the
surface.
At 10 metres/33 feet, the pressure is 2 bar/ata. An air volume taken to this depth from the surface
would decrease and become half the size. See Being a Diver I - Water Pressure and Air Volume
Effects.
4: If I am not able to equalize (clear) my body air spaces, it may be because I have
,A seasickness.
B heart disease and high blood pressure.
C a cold, allergy or another medical problem.
D anxiety. correct answers C a cold, allergy or another medical problem.
A cold, or any congestion, can block air passages in your ears and sinuses, making equalization
difficult or impossible. See Being a Diver I - The Effects of Increasing Pressure on Body Air
Spaces.
5: If my ears or sinuses hurt while I am descending (going down), it usually means
A my air spaces are equalized.
B my mask strap is too tight.
C I am feeling a squeeze and need to equalize.
D my mask is too small. correct answers C I am feeling a squeeze and need to equalize.
Pain in your ears or sinuses means that they aren't equalized. Stop your descent and ascend
slightly to relieve pressure on your ears. Then attempt to equalize again. If you can't equalize,
end the dive. See Being a Diver I - The Effects of Increasing Pressure on Body Air Spaces.
6: The best place for me to position an alternate air source is
A loose by my side so I can find it fast.
B in the triangle area formed by my chin and the lower corners of my rib cage.
C to the base of my cylinder.
D to the back of my BCD between my shoulder blades and waist. correct answers B in the
triangle area formed by my chin and the lower corners of my rib cage.
Your alternate air source attaches with a quick release in the triangle area formed by your chin
and the lower corners of your rib cage. Avoid letting your alternate air source dangle unsecured
from your kit. See Equipment I - Regulators.
7: Lung overexpansion injuries can be caused by
A scuba diving without a buddy.
B continuing a dive when not properly weighted.
C not drinking enough water before scuba diving.
D holding my breath while scuba diving. correct answers D holding my breath while scuba
diving.
Blocking off your lungs by holding your breath and ascending could cause them to overexpand
and rupture, which is a serious injury that could result in paralysis and death. Breathing
continuously while scuba diving keeps air passages open allowing expanding air to escape. See
Being a Diver I - The Effects of Decreasing Pressure on Body Air Spaces.
, 8: If my cylinder of air lasts 60 minutes while I am at the surface breathing normally, assuming
all else is the same, how long will it last at 20 metres/66 feet breathing normally?
A 60 minutes
B 20 minutes
C 15 minutes
D 12 minutes correct answers B 20 minutes
9: How often should I take my scuba cylinder to be visually inspected by my dive center?
A Once a year.
B Once every two years.
C Every six months.
D Every five years. correct answers A Once a year.
Have your cylinder visually inspected annually for internal corrosion or other
contamination/damage. See Equipment I - Cylinders.
10: The difference between DIN valves and yoke valves is that DIN valves
A are made from durable plastic.
B contain a spring-operated shutoff valve that is held open by cylinder pressure.
C have an o-ring in them.
D have threaded openings to screw the regulator into. correct answers D have threaded openings
to screw the regulator into.
With the DIN system, the regulator screws into the valve. The yoke system holds the regulator
first stage to the cylinder with a clamp system. See Equipment I - Cylinders.
11: Which of the following is part of proper care for my scuba cylinder?
A Sand and repaint it every year.
B Dry it in the sun.
C Keep some air in it.
D Have it pressure tested every month. correct answers C Keep some air in it.
You should keep some air in the cylinder to prevent moisture from entering and causing
corrosion. Also have it pressure tested at required intervals, usually two to five years. Have it
visually inspected annually. Store it standing in a safe place and keep it away from high heat. See
Equipment I - Cylinder Care.
12: Refer to the regulator picture on the right. Each regulator part has a number next to it. Please
choose the correct numeric order from the choices below.
B 1. regulator first stage, 2. regulator second stage, 3. alternate air source second stage, 4. low
pressure inflator hose for the BCD, 5. instrument console/gauges/computer. correct answers B 1.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller FullyFocus. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.
