Resistors - Study guides, Class notes & Summaries

An AC circuit consists only of a pure inductance and a power source. The relationship between the voltage and the current in this circuit is that the correct answer: current lags the voltage The power factor of a load is equal to the ____________ power divided by the ____________ power. correct answer: True ; apparent A 10-ohms and 20-ohms resistor are connected in parallel. The total line current drawn by this parallel combination is 30 amps. Under these conditions, the line voltage wil...

An inter-circuit short can cause: - ANSWER -" All of the above; Unrelated circuits to operate simultaneously; Components to work at reduced capacity; An over-current situation" Which of the following is addressed by ABYC A-32? - ANSWER -Power conditioning and conversion LED navigation lights are required to meet: - ANSWER -72 Colregs Which of the following are recommended for 3-phase shore power? - ANSWER -Power conditioning and phase-rotation monitoring Which of the following ...

ATT Test 2 Questions and Answers Latest Updated 2023 Definition of series circuit Current flows in a single path through all components In which direction does current flow? Negative to positive Current is the ____ throughout whole circuit Same 4 steps of troubleshooting Analyze, check setup, calculate/measure, check results An open series component drops _____ volts Applied Resistance is how much over open component? Max or infinite Short provide...

NEIEP 800 Final Exam Questions & Answers With Complete Solutions-Hydro elevators in low rise applications do not need an _____ _____ room. - overhead machine Some advantages of hydros are lower equipment and building construction costs because the load of a hydro is carried to the _____ where as the load of a traction car is carried by the _____ _____. - ground, building structure When drilling the jack hole, the only proper way to determine if the hole is plumb is to remove the drill stem...

A contractor wants to raise the car speed from 100fpm to 125fpm, it currently has a 12" sheave. What sheave is required? - Diam=12" 12/4=3" 25fpm=3" 100fpm + 25fpm= 12"+3"= 15" sheave A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot read voltage or resistance. What should you do? - Replace it with a larger MOV On a Ward-Leonard circuit the break is set, but the motor is trying to slip through the break. What is the issue? - Suicide Circuit You have an old DC motor ...

CETA Study Guide Questions With All Complete Solutions 8.33 meters is the full wavelength in air for what RF frequency? - ANSWER- 36 MHz Decimal 164 would appear as what in binary? - ANSWER- A resistor has color stripes yellow, violet, violet, silver. It is? - ANSWER- 470 MegOhm +/- 10% What is the total capacitance of three capacitors valued at 100uf, 100uf and 50uf when connected in series? - ANSWER- 25 pf What is the ripple frequency of a full wave single phase bridge rectif...

if a combination audible/visible appliances are installed, the location of the installed appliance shall be determined by the requirements of Answer - the visible appliance what is the maximum number of 12-gaugeTHHN conductors that can be installed in 1-inch EMT Answer - 26 Do you resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is the equivalent resistance? Answer - 150 Ohms I room is 200 feet long and 100 feet wide, and the 8 foot high ceiling is smooth and flat...

PSC1501 Portfolio. 100% CORRECT questions, answers, workings and explanations. Whatsapp +25479 093 7672 for assistance.EXPERIMENT 1 : Step 1 : What happens if an electric circuit does not have a resistor ? if there is no resistance, short circuit is connected across an dc source, infinite current will flow as I=V/R, and R=0. Practically, if you connect a wire directly across a battery, it will start heating. Resistance of short wire is in the range of Ohms which is very less as compare to re...

DELMAR UNIT 5 RESISTORS questions and answers verified 2024

Image Production - ARRT X-RAY BOARD EXAM The resistance of electric flow through a circuit is measured in: A. Volts B. Amperes C. Ohms D. Joules - ANSWER C. Ohms A circuit with a single path for electric current flow is defined as a(n): A. Parallel circuit B. Closed circuit C. Series circuit D. Open circuit - ANSWER C. Series circuit The degree of resistance provided by an individual resistor within a circuit is measure...