Academicmaterials
Sur cette page, vous trouverez tous les documents, offres groupées et cartes mémoire flash proposés par le vendeur ACADEMICMATERIALS.
- 8988
- 0
- 822
Community
- Abonnés
- Abbonements
42 Avis reçus
9824 éléments
Mobile Crane NCCER Study Guide Questions and Answers Fully Solved 100%
When making a multiple crane lift it is important for the operator to understand that - Answer-the weight may increase if the other crane lands the load first If the crane's jib is offset 5 degrees as opposed to an original 15 degrees and the boom angle remains constant you would expect the load radius to do what? - Answer-To be reduced When operating truck cranes what is the most unstable allowable quadrant of operation? - Answer-Side When working near power lines when is a signal per...
- Examen
- • 4 pages •
When making a multiple crane lift it is important for the operator to understand that - Answer-the weight may increase if the other crane lands the load first If the crane's jib is offset 5 degrees as opposed to an original 15 degrees and the boom angle remains constant you would expect the load radius to do what? - Answer-To be reduced When operating truck cranes what is the most unstable allowable quadrant of operation? - Answer-Side When working near power lines when is a signal per...
Tower Crane Questions and Answers Graded A+ 2025 Update
Slings shall be removed from service if hooks are cracked or have been opened more than_______ percent of the normal throat opening measured at the narrowest point. - Answer-15 What is the minimum allowable distance from the crane and power lines under 50 kV? - Answer-10 ft According to ASME B30.3 when working near powerlines where should caution stickers be installed? - Answer-Operator station and at the base of the crane According to OSHA a frequent inspection is: - Answer-Daily to mont...
- Examen
- • 8 pages •
Slings shall be removed from service if hooks are cracked or have been opened more than_______ percent of the normal throat opening measured at the narrowest point. - Answer-15 What is the minimum allowable distance from the crane and power lines under 50 kV? - Answer-10 ft According to ASME B30.3 when working near powerlines where should caution stickers be installed? - Answer-Operator station and at the base of the crane According to OSHA a frequent inspection is: - Answer-Daily to mont...
American Crane School (Core Practice Test 1) Questions and Answers Fully Solved 100%
You are lifting a load directly under the hook. As you put tension on it and the load lifts from the ground it swings away from the crane. What caused the increase in load radius as should have been anticipated before the lift took place? - Answer-Boom deflection A crane that is set up properly should have the tires off the supporting surface and the blocking under the float pads should be what? - Answer-Sufficient to support the crane and the load Which matches the appropriate load chart ...
- Examen
- • 4 pages •
You are lifting a load directly under the hook. As you put tension on it and the load lifts from the ground it swings away from the crane. What caused the increase in load radius as should have been anticipated before the lift took place? - Answer-Boom deflection A crane that is set up properly should have the tires off the supporting surface and the blocking under the float pads should be what? - Answer-Sufficient to support the crane and the load Which matches the appropriate load chart ...
American Crane School (Core Practice Test 3) (2025 )Latest Questions With Passed Solutions!!
What is the acceptable maximum number of broken wires at an end connecting before standing wire rope must be replaced? - Answer-Maximum number is 1 According to ANSI B30.5, the minimum distance the flange of the drum shall extend over the top layer of wire rope is? - Answer-1/2 an inch In what case is someone allowed to make modifications to the crane? - Answer-When manufacturer approves it in writing When leaving telescopic boom cranes unattended overnight or for longer periods, the boom...
- Examen
- • 4 pages •
What is the acceptable maximum number of broken wires at an end connecting before standing wire rope must be replaced? - Answer-Maximum number is 1 According to ANSI B30.5, the minimum distance the flange of the drum shall extend over the top layer of wire rope is? - Answer-1/2 an inch In what case is someone allowed to make modifications to the crane? - Answer-When manufacturer approves it in writing When leaving telescopic boom cranes unattended overnight or for longer periods, the boom...
American Crane School (Core Practice Test 2) Questions with Answers (All Answers Correct)
Examples of a duty cycle operation high speed steel erection, magnet operations, clamshell operations and? - Answer-High volume concrete placement When preforming a pick and carry operation, an operator should keep the boom? - Answer-In line with the direction of travel When operating a crane that does not have the telescopic boom sections extended equally, which of the sections would likely become overloaded? - Answer-The longest section Based only on permissible line pull of 13,920 lbs,...
- Examen
- • 4 pages •
Examples of a duty cycle operation high speed steel erection, magnet operations, clamshell operations and? - Answer-High volume concrete placement When preforming a pick and carry operation, an operator should keep the boom? - Answer-In line with the direction of travel When operating a crane that does not have the telescopic boom sections extended equally, which of the sections would likely become overloaded? - Answer-The longest section Based only on permissible line pull of 13,920 lbs,...
American Crane School (Core Practice Test 4) Questions and Answers Fully Solved 100%
By order of hitch strength from strongest to weakest which is the correct answer? - ️️Basket, Vertical, Choker when rigging a load that requires two slings, an important factor to remember is that? - ️️The lower the sling angle the greater the sling tension Load chart ratings apply when the load line is? - ️️Vertical When performing duty cycle work you shall reduce the cranes rated capacity by what? - ️️Manufacturers recommendations If a crane is working on the tires it is...
- Examen
- • 4 pages •
By order of hitch strength from strongest to weakest which is the correct answer? - ️️Basket, Vertical, Choker when rigging a load that requires two slings, an important factor to remember is that? - ️️The lower the sling angle the greater the sling tension Load chart ratings apply when the load line is? - ️️Vertical When performing duty cycle work you shall reduce the cranes rated capacity by what? - ️️Manufacturers recommendations If a crane is working on the tires it is...
Articulating Boom Crane Practice Test #1 2025 Update Questions & Answers Graded A+
When is it permissible to side load the machine a. Never b. When you cannot center the boom tip over the load c. Only to pull a load weighing less than 1,000 pounds d. When the tires are completely off the ground - Answer-a. Never Which of the following should always be done? a. Watch out for the safety of the signal person b. Move the vehicle if a load is suspended from the crane c. Walk or stand under a suspended load d. All of the above - Answer-a. Watch out for the safety of the sig...
- Examen
- • 4 pages •
When is it permissible to side load the machine a. Never b. When you cannot center the boom tip over the load c. Only to pull a load weighing less than 1,000 pounds d. When the tires are completely off the ground - Answer-a. Never Which of the following should always be done? a. Watch out for the safety of the signal person b. Move the vehicle if a load is suspended from the crane c. Walk or stand under a suspended load d. All of the above - Answer-a. Watch out for the safety of the sig...
WGU C215 Pre-assessment PVDC Update 2025 Questions And Answers Already Graded A+
What would be an organization's next step after it has revised or implemented new operations? - Answer-Follow up to make sure the new operation resolves quality problems Why is it beneficial for an organization to designate employees to communicate alternative ways to complete a job in a methods analysis? - Answer-They may have suggestions for improving the operation. Which factor determines how long it takes a qualified operator to perform a duty of the job requirements under the assu...
- Examen
- • 7 pages •
What would be an organization's next step after it has revised or implemented new operations? - Answer-Follow up to make sure the new operation resolves quality problems Why is it beneficial for an organization to designate employees to communicate alternative ways to complete a job in a methods analysis? - Answer-They may have suggestions for improving the operation. Which factor determines how long it takes a qualified operator to perform a duty of the job requirements under the assu...
WGU C215 Study Guide ( 2025) Update Graded A+ Questions and Answers Fully Solved 100%
Third-Party Logistics (3PL) - Answer-Businesses used to outsource elements of the company's distribution and fulfillment services. They typically specialize in integrated operation, warehousing and transportation services which can be scaled and customized to customers' needs based on market conditions, such as the demands and delivery service requirements for their products and materials. Process Capability Index (Cpk) - Answer-Basic function of Six Sigma. Measures the process poten...
- Examen
- • 4 pages •
Third-Party Logistics (3PL) - Answer-Businesses used to outsource elements of the company's distribution and fulfillment services. They typically specialize in integrated operation, warehousing and transportation services which can be scaled and customized to customers' needs based on market conditions, such as the demands and delivery service requirements for their products and materials. Process Capability Index (Cpk) - Answer-Basic function of Six Sigma. Measures the process poten...
WGU-C215-Operations Management-Chp15 Questions and Answers Fully Solved 100%
infinite loading - ️️scheduling that calculates the capacity needed at work centers in the time period needed without regard to the capacity available to do the work input/output control - ️️a technique for monitoring the flow of jobs between work centers internal resource constraint - ️️a regular bottleneck backward scheduling - ️️scheduling method that determines when the job must be started to be done on the due date due date - ️️time when the job is supposed to be ...
- Examen
- • 1 pages •
infinite loading - ️️scheduling that calculates the capacity needed at work centers in the time period needed without regard to the capacity available to do the work input/output control - ️️a technique for monitoring the flow of jobs between work centers internal resource constraint - ️️a regular bottleneck backward scheduling - ️️scheduling method that determines when the job must be started to be done on the due date due date - ️️time when the job is supposed to be ...
Kappa Beta Gamma Questions With Complete Solutions!!
BIO 156 EXAM 1 QUESTIONS WITH 100 % CORRECT ANSWERS | VERIFIED
Law of Agency - Champions School of Real Estate 2024 Latest Questions With Passed Solutions!!
HC21- Legal & Ethical Responsibilities Questions and Answers New (2024/2025) Solved 100% Correct
Indiana Life & Health Insurance Exam Questions with Answers (All Answers Correct)