JATC JW TEST || A+ Graded Already

The term kcmil is used when referring to cables larger than? correct answers 4/0 The ____ is the unit of area used to measure the cross sectional area of wire. correct answers Circular mil Convert 500 microamps to milliamps. correct answers 0.5 ma. 500uAx1mA/1000uA=.5mA If you bought a 2 liter bottle of wire lubricant approximately how many pints did you buy. Given 1 pint = .04732 liter correct answers 4 and 1/4 pints. 2Lx1P/.4732L The most common method of producing electricity is through the use of? correct answers Magnetism The unit of current flow is the? correct answers Ampere Only ____ can use power in an electrical circuit. correct answers Resistance Identify the symbol shown in the figure below ---o/ o--- correct answers Normally-open switch Current flow through a circuit is ____ by resistance in the circuit. correct answers Limited If you increase the voltage in a series circuit, the current will? correct answers Increase Calculate the total power dissipated in a series circuit supplied by 24 volts with the following loads Given: R1=8ohms, R2=4ohms correct answers 48 watts The total resistance of a parallel circuit is ____ the value of the lowest value resistor. correct answers Less than In a parallel circuit, in which branch is the greatest amount of power consumed. correct answers Branch of least resistance Which formula below will not help you find the total power in a combination circuit? correct answers P=I2/R In a three-wire, single-phase system, what is the maximum UNBALANCED load the neutral conductor must be able to carry? correct answers The full load of either leg all generators produce ____ voltage. correct answers AC