NACE CIP 1 CBT EXAM PRACTICE QUESTIONS AND COMPLETE SOLUTIONS

NACE CIP 1 CBT EXAM PRACTICE QUESTIONS AND COMPLETE SOLUTIONS Dew point is the temperature at which. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of action is to: If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a Upon arrival of coating materials, the inspector should Relative humidity is Galvanic corrosion occurs on which of the following substrates? When applying Thermal Spray Coatings the specification is most likely to reference: What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial type magnetic pull off Dry Film Thickness(DFT) gauge? Polymerization is the process of? An exposed area of the substrate or previous coat of a conductive material, often caused by poor application technique is called: Checking is: Inspection documentation is important because: An Inspectors personal log book should contain: You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors. Your FIRST preferred course of action is to:. Good record can provide maintenance departments with detailed information about ALL of the following EXCEPT:. Non Conformance Reports are completed by the Inspector: The initial steel condition is important to the NACE Inspector because: The form of corrosion that has the largest potential for unexpected catastrophic failure is: What is used to determine compressed air cleanliness? Osmotic blistering is most likely to occur as a result of: When performing tests for oil and grease using an ultra violet light, the NACE Ins pector should be aware that:. To achieve consistently accurate results with ALL alt test equipment: When holiday testing is required the Inspector is always required to enforce what standard? If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is: Fine cracks in the surface of a coating that rarely reach the substrate are called: It is good practice for the NACE Inspector to have instrument calibration certificates available:. In a non convertible coating the role of the primary solvent is to: Removal of weld splatter is required:. Common errors that may produce inaccurate readings when using a Dial Type Magnetic Pull Off Dry Film Thickness(DFT) gauge include: Conventional spray us good choice when: Which of these tests uses a syringe? Which one of these elements is not necessary for corrosion to occur: Digital hygrometers Using SSPC Vis 1 as a guide when performing a visual inspection of a steel surface prior to surface preparation a NACE Inspector would assign which designations to the surface condition: Inspectors daily reports are used:. Silicone coatings are typically:. Excess moisture during holiday testing can cause erroneous by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection. This is often referred to as? ASTM Standards are applicable:. The main responsibilities of the Inspector are to: When using a sling psychrometer a very large difference between the wet and dry bulb readings indicates: The NACE Inspector should perform tests for soluble salts: Corrosion generally occurs at which of the following sites: If Inspectors identify issues of non conformance during an inspection, they should: You are the NACE Inspector on a job where ISO ST 3 has been specified. The Contractor normally works to SSPC standards and been referencing SSPC SP 3. Could this have any impact on the final surface preparation appearance? Safety Data Sheets must be carefully reviewed by