TCFP Questions and Accurate Answers

TCFP Questions Which is a characteristic of smooth bore nozzles? A. Prone to clogging with debris B. Cannot be used to apply compressed air foam C. Cannot be adjusted to different stream patterns D. Operate at higher nozzle pressures than fog nozzles - C. Cannot be adjusted to different stream patterns How is the rate of discharge for a manually adjustable fog nozzle changed? A. Pushing the bale forward or backward slowly B. Rotating the nozzle tip to choose a wider or narrower pattern C. Rotating the selector ring to the desired GPM (L/min) setting D. Signaling the pump operator to reduce or increase the pressure - C. Rotating the selector ring to the desired GPM (L/Min) setting Advancing an uncharged hose line down a flight of stairs is only recommended when: A. The fire is minor or not present B. There is an immediate need for water C. The primary search has been completed D.There are at least four firefighters on the hoseline team - A. The fire is minor or not present Hand line streams have flows that discharge: A. Less than 40 GPM ( 160 L/min) B. From 25 to 300 GPM ( 100 to 1 200L/min) C. From 40 to 350 GPM (160 to 1 400L/min) D. More than 350 GPM ( 1 400L/min) - From 40 to 350 GPN (160 to 1 400L/min Which type of hose stream is created by specialized nozzles such as cellar nozzles, piercing nozzles, or chimney nozzles? A. Fog stream B. Solid stream C. Broken stream D. Straight stream - C. Broken stream What is caused by friction loss? A. Increased nozzle reaction B. Decreased nozzle reaction C. Lower water pressure at the pump D. Lower water pressure at the nozzle - D. Lower water pressure at the nozzle Class a foam acts as a surfactant, which means that it: A. Requires a special type of nozzle for application B. Requires a special type of aeration tool to be formed C. Lowers the surface tension of water, allowing better penetration into the fuel D. Raises the surface tension of water, creating a more effective extinguishing agent. - C. Lowers the surface tension of water, allowing better penetration into the fuel. The rate of application for class B foam depends on: A. The location of the fuel spill B. Whether or not the fuel is a surfactant C. The type of water used to proportion the foam D. Whether the fuel is spilled or contained in a tank - D. Whether the fuel is spilled or contained in a tank What is necessary when applying fire fighting foam? A. A vapor protective suit and SCBA B. A hazardous materials team standing by C. Continued, uninterrupted application until extinguishment D. Intermittent application breaks to allow the foam to settle - C. Continued, uninterrupted application until extinguishment Mixing water with foam concentrate to form a foam solution is referred to as: A. Aerating B. Surfacting C saponifying D. Proportioning - D. Proportioning Most fire fighting films are intended to be mixed with: A. 30to60% water B. 50 to 75.9% water C. 80 to 90% water D. 94 to 99.9% water - D. 94 to 99.9% water Class B foams are especially effective on A. Surfactants B. Hydrocarbon fuels C. Ordinary combustibles D. Energized electrical equipment - B. Hydrocarbon fuels Which type of foam proportioner is directly attached to the pump panel outlet or connected at some point in the hose lay? A. In line eductor B. Foam nozzle eductor