MT LEVEL I / II questions with correct answers
Iron filings Correct Answer-Magnetic particle inspection uses small
ferromagnetic particles similar to:
A magnetic field Correct Answer-A volume of space where there is a
change in magnetic energy is called:
Ferromagnetic materials Correct Answer-Which of the following has a
large susceptibility to magnetic field?
Iron, nickel, cobalt Correct Answer-Magnetic particle inspection can be
performed on parts made from which materials?
A magnetic pole Correct Answer-A location where a magnetic field can
be detected exiting or entering a material is called:
Higher residual magnetism Correct Answer-A material with a wider
hysteresis loop has:
North pole Correct Answer-The area where the exit poles are
concentrated is called the magnet's:
Domains Correct Answer-Ferromagnetic materials are made up of small
polarized regions known as:
, Magnetic poles form at the edges of the crack Correct Answer-When a
magnetic field cuts across a crack:
Coercive force Correct Answer-The force required to remove the
residual magnetism from the material is called the:
Residual magnetism Correct Answer-The magnetic flux density that
remains in the material when the magnetizing force is zero is called:
In two directions at right angles to each other Correct Answer-When
testing parts with magnetic particles, it is best to magnetize the part:
Between the north and south poles of the yoke Correct Answer-A yoke
establishes a magnetic field:
Increase wear by attracting abrasive particles. Correct Answer-
Components generally must be demagnetized because residual
magnetism can:
Along the inside edge of the coil Correct Answer-When performing a
magnetic particle test with a coil, the part should be placed:
Magnetically saturated Correct Answer-When all the magnetic domains
are aligned, the material is said to be:
Iron filings Correct Answer-Magnetic particle inspection uses small
ferromagnetic particles similar to:
A magnetic field Correct Answer-A volume of space where there is a
change in magnetic energy is called:
Ferromagnetic materials Correct Answer-Which of the following has a
large susceptibility to magnetic field?
Iron, nickel, cobalt Correct Answer-Magnetic particle inspection can be
performed on parts made from which materials?
A magnetic pole Correct Answer-A location where a magnetic field can
be detected exiting or entering a material is called:
Higher residual magnetism Correct Answer-A material with a wider
hysteresis loop has:
North pole Correct Answer-The area where the exit poles are
concentrated is called the magnet's:
Domains Correct Answer-Ferromagnetic materials are made up of small
polarized regions known as:
, Magnetic poles form at the edges of the crack Correct Answer-When a
magnetic field cuts across a crack:
Coercive force Correct Answer-The force required to remove the
residual magnetism from the material is called the:
Residual magnetism Correct Answer-The magnetic flux density that
remains in the material when the magnetizing force is zero is called:
In two directions at right angles to each other Correct Answer-When
testing parts with magnetic particles, it is best to magnetize the part:
Between the north and south poles of the yoke Correct Answer-A yoke
establishes a magnetic field:
Increase wear by attracting abrasive particles. Correct Answer-
Components generally must be demagnetized because residual
magnetism can:
Along the inside edge of the coil Correct Answer-When performing a
magnetic particle test with a coil, the part should be placed:
Magnetically saturated Correct Answer-When all the magnetic domains
are aligned, the material is said to be:
