IMSA Traffic Signal Inspector Chapter 1 – Introduction 100% ACCURATE EXAM BUNDLE

Safety Education - ANSWER Primary function of the IMSA International Municipal Signal Association - ANSWER IMSA Stands for: Circular Red, Circular Green - ANSWER What are the sections of a ramp meter signal? Personal Protective Equipment - ANSWER PPE Stands for:

What is the primary function of the IMSA? - ANSWER Safety Education Which of the following is NOT an IMSA certification? - ANSWER Y: Traffic Signal Level II Design/Engineer TechnicianY: Traffic Signal Level II Field TechnicianY: Traffic Signal Level II Bench TechnicianN: Traffic Signal Level III ...

Where are you when you install alternating flashing 12" red lights? - ANSWER At a railroad crossing. Who determins the the standards on traffic control devices and sets the requirements for uniformity? - ANSWER The Manual on uniform traffic control devices, (MUTCD). What is the the voltage th...

MUTCD - ANSWER Part 4 OSHA - ANSWER Safety Date Sheets (SDS) - 16 sections NEC - ANSWER National Electric Code, smaller (house, cabinet) NESC - ANSWER National Electrical Safety Code, bigger (utilities)

Ampacity - ANSWER The maximum current, in amperes, that a conductor can carry continuously under the conditions of use without exceeding its temperature rating. Bonded (Bonding) - ANSWER Connected to establish electrical continuity and conductivity. Bonding Jumper, Main - ANSWER The connection...

High-Traffic Areas - ANSWER High-volume streets, such as arterials. Typically wide and have multiple lanes of travel. Low-Traffic Areas - ANSWER Low-volume streets such as local streets or collector streets. Typically narrow and have single lanes of travel. Insulated Hand Tools - ANSWER Tools ...

Which are the two Traffic Signal Level 3 - ANSWER Bench Electrical (Field) Personal safety is a matter of - ANSWER Regulation and common sense The voltage that the signal operate on is... - ANSWER 120 VAC

On the shoulder adjacent to traffic being controlled - ANSWER The work zone starts at the first advance warning sign; therefore, where should the flagger stand when directing traffic in a TTC zone? three - ANSWER How many orange and black TTC signs should there be in each direction on a 2-way, 2-...

What should you do first before preforming duties in the proximity of overhead power lines ? - ANSWER They must communicate with the power company prior to starting the work and coordinate the activities that a representative of the power company can be in attendance to assist while the work is bein...

The information within this study guide is intended to ______________ roadway lighting systems and service. a. reduce the cost of b. highlight the importance of c. further knowledge and understanding of d. define specifications for - ANSWER c. The main purpose of lighting roadways and other...

What does MUTCD stand for? - ANSWER Manual on Uniform Traffic Control Devices In the MUTCD manual, a standard includes what words? - ANSWER should, shall, may In the MUTCD manual, guidance does not inlcude what words? - ANSWER should

A traffic cycle / ( cycle length ) definition is ? - ANSWER Is the total elapsed Time between the start of a specific display until the display comes up again. Example ( if the cycle starts at the beginning of a green display it will end when The same green display begins again after the red and...