Carpentry EOPA study 1. Questions and answers, VERIFIED.

Carpentry EOPA study 1. Questions and answers, VERIFIED. The common causes of accidents are failure to follow instruction, poor behavior and poor working conditions, and improper training. Ultimate responsibility falls on - -you 2) OSHA rules are established to protect the lives of American workers. The 10 hour certification focus on - -identification, avoidance, control and prevention. 3) When using a Ladder, always maintain - -three point contact Extension ladders require a __________ ratio which means for every 4 feet up, the base must come 1 foot out. - -4 to 1 When working at elevations above__________, a safety harness with lanyard is required. - -6 feet ___________educates employees about hazardous chemicals. - -Haz-Com ____________identifies substances, exposure limits, physical and chemical characteristics, contact information and first aid. - -A material safety data sheet (MSDS) When backing up and if view is obstructed, use a reverse horn or ____________ - -a person as a signal guide. All trenches over 4 feet deep must have _____________for every 25 feet. - -approved ladder OSHA requires that an attendant must remain outside to monitor safety of workers that are on the _____. - -inside Transit level and leveling rod are used for building layout and ________. - -elevations The rod is usually broken down into ________ of a foot - -tenths A transit can transfer horizontal points from _______. - -one floor to another a) A combination square is used for 45-degree