100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Michigan State Brakes Certification Exam Questions and Answers CA$16.54   Add to cart

Exam (elaborations)

Michigan State Brakes Certification Exam Questions and Answers

3 reviews
 501 views  15 purchases
  • Course
  • MICHIGAN STATE BRAKES
  • Institution
  • MICHIGAN STATE BRAKES

Michigan State Brakes Certification Exam Questions and Answers Most 1995 & newer vehicles use which of the following types of wheels bearings on non-drive wheel? - ANSWER ️️ Sealed non-serviceable to test a vacuum power brake booster in the vehicle, you should pump the brake pedal at least...

[Show more]

Preview 2 out of 6  pages

  • December 10, 2023
  • 6
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers
  • MICHIGAN STATE BRAKES
  • MICHIGAN STATE BRAKES

3  reviews

review-writer-avatar

By: jeffnauseda • 3 months ago

Great study guide

review-writer-avatar

By: dbonedruckenbroke • 6 months ago

reply-writer-avatar

By: KatelynWhitman • 6 months ago

Appreciating for the positive feedback, Success!!!

review-writer-avatar

By: ssmoon187 • 1 week ago

avatar-seller
Michigan State Brakes Certification Exam
Questions and Answers

Most 1995 & newer vehicles use which of the following types of wheels bearings
on non-drive wheel? - ANSWER ✔️✔️Sealed non-serviceable
to test a vacuum power brake booster in the vehicle, you should pump the brake
pedal at least 4 times, hold the brake pedal depressed, and start the engine. the
brake pedal should: - ANSWER ✔️✔️drop slightly and remain firm
You are installing a set of brake shoe linings that are not the same length.
Traditionally, the primary shoe lining is: - ANSWER ✔️✔️Smaller and goes
towards the front of the car.
A cracked or torn vacuum diaphragm in a brake power booster would most likely
cause: - ANSWER ✔️✔️a hard pedal feel requiring very high pedal effort to stop
A mechanic finds gear lube inside both rear brake drums on a rear wheel drive
vehicle. What is the most likely cause of this problem? - ANSWER ✔️✔️A plugged
axle
Which of the following incorrect service procedures will cause brake lock-up? -
ANSWER ✔️✔️master cylinder push rod adjusted too long
Which of the following describes the proper way to depressurized an ABS system?
- ANSWER ✔️✔️Pump the brake pedal at least 25 times (or more, depending on the
manufacturer's recommendation) with the ignition off.
The rear brakes are dragging after having new linings installed and the drums
machined. the most likely cause is the: - ANSWER ✔️✔️technician use the parking
brake to adjust shoes and the cable is stuck
When turning brake drums: - ANSWER ✔️✔️use a dampening strap to reduce
chatter

, Which of the following is NOT a necessary drum brake measurement? - ANSWER
✔️✔️run-out
On a 3-channel system, which wheels are on the same circuit? - ANSWER
✔️✔️both rear wheels
One way to test an ABS wheel speed signal is to use _____ on your digital
multimeter. - ANSWER ✔️✔️AC volts

The key input for the ABS control module comes from the: - ANSWER ✔️✔️wheel
speed sensors
ABS speed sensor and sensor rings: - ANSWER ✔️✔️should not be hammered or
tapped on and should always be replaced as a matched set
Flexible brake hoses should be replaced: - ANSWER ✔️✔️when dampness is
evident on the hose
Which of the following should be used to check for rotor thickness variation: -
ANSWER ✔️✔️Micrometer
After rebuilding a master cylinder, the rod between the master cylinder and booster
should be: - ANSWER ✔️✔️adjusted properly
Upon inspecting brake fluid condition, the technician observes the diaphragm in
the master cylinder cup is swollen. Which of the following is the most likely
cause? - ANSWER ✔️✔️silicone fluid added to the system
When inspecting brake fluid levels, a technician observes low fluid levels. which
of the following should be done first? - ANSWER ✔️✔️Inspect disc brake pads for
excessive wear
Which of the following is true about most properly functioning anti-lock brake
systems? - ANSWER ✔️✔️The brakes may lock up at speeds less than 10 miles per
hour
Which of the following is true about bleeding brake lines on most ABS equipped
vehicles? - ANSWER ✔️✔️Most ABS brake lines can be bled like a conventional
(non-ABS) system. However, caution must be taken because of the extreme
pressure.

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller KatelynWhitman. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for CA$16.54. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

84866 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
CA$16.54  15x  sold
  • (3)
  Add to cart