Exam (elaborations)
ASE A4 Steering and Suspension Questions with 100% correct answers verified latest update 2024
- Course
- Institution
ASE A4 Steering and Suspension Questions with 100% correct answers verified latest update 2024
[Show more]
Seller
Follow
ACTUALSTUDY
Reviews received
Content preview
ASE A4 Steering and SuspensionWhich of the following is the proper way to adjust the rack yoke bearing?
A. Tighten to 75 ft lbs.
B. Tighten to 5 inch lbs.
C. Tighten and then back off the original equipment manufacturer's (OEM)
✅✅
specifications.
D. Tighten to 0.002" end-play. - -Tighten and then back off the originial
equipment manufacturer's (OEM) specifications. Many OEMs will recommend that
the technician tighten to a specification then back off a certain number of degrees.
A customer says that the steering wheel turns more turns to the left than the right.
Which of the following is the LEAST LIKELY cause?
A. Incorrectly timed steering gear
B. Bent pitman arm
✅✅
C. Faulty power steering pump
D. Bent tie rod - -Faulty power steering pump. A faulty power steering pump
would not change the relationship between the steering wheel and the steering
stops.
A vehicle is hard to steer in one direction only. Which of the following could be the
cause?
A. Tight joint in the steering shaft
B. Loose joint in the steering shaft
✅✅
C. Faulty power steering pump
D. Fault power steering gear - -Faulty power steering gear. A leaking seal in a
power steering gear could affect steering in both directions.
The rear tires have a diagonal wear pattern. Which of the following is the most likely
cause?
A. Rear toe
B. Rear camber
✅✅
C. Front camber
D. Front caster - -Rear toe. Incorrect rear toe causes a diagonal swipe wear
pattern on rear tires.
A customer says their car makes more noise on asphalt than on concrete road
surfaces. Which of the following could be the cause?
A. Front wheel bearing wear
B. Rear wheel bearing wear
C. Aggrresive tire tread patterns
,D. Incorrect alignment angles - ✅✅ -Aggressive tire tread patterns. Tires with very
aggressive tread patterns are noisy. This noise will vary with different types of finish
on the road surface.
There is a loud roaring noise while driving. The noise gets louder when vehicle
speed increases. Which of the following could be the cause?
A. Worn power steering pump
B. Worn wheel bearing
✅✅
C. Worn ball joint
D. Worn power steering gear - -Worn wheel bearing. This is a typical wheel
bearing diagnosis.
A setback condition is found during an alignment. Which of the following could be the
cause?
A. Worn spring shackle
B. Worn spring eye bushing
✅✅
C. Worn tie rod end
D. Worn pitman arm - -Worn spring eye bushing. A worn spring eye bushing
could allow the rear axle to shift and setback to occur.
There is a whining noise heard only when turning. Which of the following could be
the cause?
A. Leaking internal seals in the steering gear
B. Worn ball joint
✅✅
C. Worn power steering gear
D. Worn power steering pump - -Worn power steering pump. A worn power
steering pump can cause noise while turning.
The front leaf springs have been replaced on a vehicle. Which of the following
operations must also be performed.
A. Vehicle alignment
B. Tire rotation
✅✅
C. Tire balance
D. Rear spring replacement - -Vehicle alignment. After the springs are
replaced, the vehicle alignment will be changed. Therefore, the vehicle must be
aligned.
A vehicle has worn jounce bumpers. Which of the following could be the cause?
A. Leaking shocks
B. Leaking power steering pump
✅✅
C. Leaking power steering gear
D. Worn strut bearings - -Leaking shocks. Leaking shocks can allow the vehicle
to bottom out on rough road surfaces.
,A worn idler arm would affect which alignment angle?
A. Camber
B. Caster
✅✅
C. Toe
D. SAI - -Toe. Toe is directly affected by the idler arm. A worn idler arm would
allow toe to change while traveling down the road.
A shifted front cradle could affect any of these EXCEPT:
A. Front camber.
B. Front caster.
✅✅
C. Thrust line.
D. Thrust angle. - -Thrust line. The thrust line is the direction the rear wheels
are pointing; this would not be affected by a shifted front cradle.
There is a pull on acceleration and deceleration. Technician A says spring eye
✅✅
bushings could be the cause. Technician B says worn strut rod bushings could be
the cause. Who is right? - -Both Technicians are correct. Spring eye bushings
and worn strut rod bushings can both allow the control arm to move when the vehicle
is driven.
A composite leaf spring is being installed in a vehicle. Which of the following is
correct?
A. The spring can be installed using a pry bar.
B. The spring can be compressed with vise grips.
✅✅
C. The spring should be painted after installation.
D. The spring should not be scratched during installation. - -The spring should
not be scratched during installation. The spring needs to be handled with care. If the
spring is dented or scratched, it will be weakened and break.
Which of the following alignment specification would most likely need a steering
damper.
A. 6 degrees caster.
B. 2 degrees camber
✅✅
C. 2 degrees caster
D. 6 degres camber - -6 degrees caster. Vehicles with high caster settings are
most likely to use a steering damper to help control front-wheel shimmy.
A customer complains of a popping noise while turning the steering wheel. Which of
the following is the most likely cause?
A. Rear shock mounts
B. Rear toe adjusters
✅✅
C. Front shock mounts
D. Front tie rods - -Front tie rods. Worn front tie roads can make a popping
noise when the steering wheel is rocked back and forth.
, A power steering pump hose is leaking on a vehicle. Which of the following is the
most likely cause?
A. Separated motor mounts
B. Loose drive belt
✅✅
C. Air in the fluid
D. Broken pump mounts - -Separated motor mounts. It is possible that
separated motor mounts could cause the hoses to be stretched and leak.
Which angle has the greatest affect on steering wheel return?
A. Camber
B. SAI
✅✅
C. Toe
D. Caster - -Caster. Caster greatly affects steering wheel return.
There is a vibration which can be felt in the steering wheel at speeds above 30 mph.
Which of the following could be the cause?
A. Front wheels out of balance
B. Rear wheels out of balance
✅✅
C. Caster
D. Camber - -Front wheels out of balance. A vibration felt in the steering wheel
is most likely caused by the front wheels being out of balance.
The hole in the steering knuckle into which the ball joint stud goes is out of round.
Which of the following is the best method of repair.
A. Measure the wear and check against manufacturer's specifications.
B. Replace the steering knuckle
✅✅
C. Ream the hole.
D. Shim the hole. - -Replace the steering knuckle. The steering knuckle must
be replaced.
The left front tire on a vehicle shows outside tread wear. Which of the following is the
most likely cause?
A. Worn shock absorbers
B. Tires overinflated
✅✅
C. Camber adjustment incorrect
D. Caster adjustment incorrect - -Camber adjustment incorrect. Excessive
positive camber will cause cupping across the tire tread.
Which of the following would cause toe-out-on-turns to be out of specification?
A. Bent tie rods
B. Bent steering arm
C. Bent lower control arm
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller ACTUALSTUDY. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for CA$11.19. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
77824 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now