100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
ASE A5 Practice Test 90 Questions with 100% Correct Answers CA$16.57   Add to cart

Exam (elaborations)

ASE A5 Practice Test 90 Questions with 100% Correct Answers

 7 views  0 purchase
  • Course
  • ASE
  • Institution
  • ASE

ASE A5 Practice Test 90 Questions with 100% Correct Answers 1. On a car with disc/drum brakes, the front brakes grab quickly when light pedal pressure is applied. This problem could be caused by a bad: A. proportioning valve B. pressure safety switch C. metering valve D. residual check valv...

[Show more]

Preview 4 out of 39  pages

  • August 28, 2024
  • 39
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • ASE
  • ASE
avatar-seller
©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




ASE A5 Practice Test 90 Questions with
100% Correct Answers

1. On a car with disc/drum brakes, the front brakes grab

quickly when light pedal pressure is applied. This problem

could be caused by a bad:

A. proportioning valve

B. pressure safety switch

C. metering valve

D. residual check valve - Answer✔️✔️-C

2. The driver of a vehicle with power disc/drum brakes

says that the brake pedal moves slowly to the floor while

maintaining pedal pressure at a stoplight. What could

cause this problem?

A. leaking primary piston cup in master cylinder

B. leaking power brake booster

C. leaking residual check valve in master cylinder

D. internal leak in the combination valve - Answer✔️✔️-A

3. Which of the following would MOST LIKELY happen




1

, ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




if the measurements taken from the check shown above

varied from the manufacturer's specifications?

A. noisy brake operation

B. brake grab or pull

C. pulsating brake pedal

D. low brake pedal - Answer✔️✔️-C

4. What is the purpose of the master cylinder residual

check valve(s) on vehicles equipped with drum brakes?

A. allows the driver to pump up the brakes

B. prevents air from entering the hydraulic system

C. prevents wheel lockup by reducing the hydraulic

pressure

D. reduces pedal pulsation by controlling hydraulic

pressure - Answer✔️✔️-B

5. A technician has just overhauled the front brakes on a

vehicle with front disc and rear drum brakes. However, when

he attaches a pressure bleeder (pressurized to about 25

psi) to the master cylinder, he cannot get any fluid to come

out of the disc brake caliper bleeder screws. Which of the



2

, ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




following is MOST LIKELY the cause?

A. bad proportioning valve

B. bad pressure differential valve

C. proportioning valve release button not activated

D. metering valve release button not activated - Answer✔️✔️-D

6. On a vehicle with single piston floating caliper front disc

brakes, the brake pads on the left side of the vehicle are

almost completely worn while the right side is almost new.

Technician A says that too much rotor runout could be

the cause. Technician B says that a binding caliper piston

could be the cause. Who is right?

A. Technician A only

B. Technician B only

C. Both A and B

D. Neither A or B - Answer✔️✔️-B

7. What is the purpose of the bar that is being removed

from the brake assembly shown below?

A. to equalize the braking force between the shoes

during normal braking



3

, ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




B. to center the shoes after each brake application

C. to force the shoes into the drum when the parking

brakes are applied

D. to reduce the distance between the shoes and the

drum - Answer✔️✔️-C

8. A hydraulic brake line is leaking. Which of the following is

the correct repair procedure?

A. Cut out the bad section and replace with new steel

tubing using compression fittings.

B. Replace the leaking line with double-flared, seamless

copper tubing.

C. Cut out the bad section and replace with single-flared

steel tubing using flare nuts and unions.

D. Replace the leaking line with double-flared steel

tubing. - Answer✔️✔️-D

9. The set-up shown above is used to check: (dial indicator on rotor
face)

A. rotor parallelism

B. wheel bearing adjustment




4

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller SophiaBennett. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for CA$16.57. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

79373 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling

Recently viewed by you


CA$16.57
  • (0)
  Add to cart